Skyrc SK-DIS10100 User manual

Thank you for purchasing the SkyRC AAA battery
discharger. Please read these instructions carefully
and thoroughly before operating this unit.
1. Put 1 – 4 cells of NiMH batteries into the slot. Make
sure polarity of the batteries are in right direction.
- Eliminate memory effect of NiMH cells and maximize
battery life.
- Four independent discharging slots.
- LED indicators for easy check of discharging status.
- 1000mA current for fast discharging.*
- Aluminum case for superior heat dissipation.
- Screw type battery terminal is comfortable to fix
battery.
* Discharging time will vary depending upon the brand,
capacity, and condition of batteries being discharged.
INSTRUCTION MANUAL
- Do not discharge battery cells other than NiMH AAA
Batteries
- Do not operate the discharger if it appears damaged
in any way.
- The discharger will get hot while in use. Do not
touch it.
- Operate in well ventilated area.
- Always place the battery cells with right polarity.
Incorrect polarity may cause damage.
GENERAL PRECAUTIONS
FEATURES
OPERATION INSTRUCTION
AAA Battery Discharger
SK-DIS10100
- 1 - - 2 -

2. Tighten the screws gently until their tips touch to
the batteries. LEDs will glow when you put 2 cells
on 1-2 slots or 3-4 slots. If you put only one cell in
any slot, the LED will not turn on. However the
battery is under discharging process. (To turn on
the LEDs, you need 2 cells in pair)
3. When LEDs turn off, please unscrew 4 screws and
take out the batteries from the tray.
Size 72.5X56X26.6mm
Weight 81g
Battery type AAA size, NiMH only
Cell of discharge 1 - 4 cell
Max. discharge current 1,000mA
Cut off voltage 0.9V (Please take out
battery from discharger
after cut off)
Status of discharge Discharging: LED glow.
Finished: LED off
Case Materials Aluminum
SPECIFICATION
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Manufactured by
SKYRC TECHNOLOGY CO., LTD.
www.skyrc.com
- 3 - - 4 -