SOMFY Keytis NS2RTS Owner's manual

http://www.remotecontrol-
express.com
SOMFY Keytis NS2RTS
Pro ram
min of your new remote control
Receiver type 1 (fi .1):
1.
Open the casin of your receiver. It is located next to your motor.
2.
On the receiver circuit board, press the pro rammin button «
li ht L1 on
the receiver illuminates.
3. Press a button on
your new remote control. Let it o. The LED li ht o
then turns off (4).
4. Wait 10 seconds.
5.
Your new remote control is pro rammed.
Receiver type Axroll (fi .2) :
1.
Open the casin of your receiver.
2.
On the receiver circuit board, press on the arrows until you et to the position P.8 on the
di ital screen.
3. After
a second, the position 0.0 appears on the screen which corresp
function of your door.
4.
Simultaneously press the button you wish to pro ram on your new remote control and the +
button in your receiver for three seconds.
o.
5. Wait 10 seconds.
6. Your new
remote control is pro rammed.
Programming Manual
express.com
- TEL : [phone] - FAX :
[phone]
SOMFY Keytis NS2RTS
-
Keytis NS4RTS
min of your new remote control
:
Open the casin of your receiver. It is located next to your motor.
On the receiver circuit board, press the pro rammin button «
Pro 1 »
(fi 1) until the LED
the receiver illuminates.
your new remote control. Let it o. The LED li ht o
n
the receiver blinks and
Your new remote control is pro rammed.
Open the casin of your receiver.
It is located next to your motor.
On the receiver circuit board, press on the arrows until you et to the position P.8 on the
a second, the position 0.0 appears on the screen which corresp
onds to the open/close
Simultaneously press the button you wish to pro ram on your new remote control and the +
button in your receiver for three seconds.
Two dashes appear on the screen. Let the buttons
remote control is pro rammed.
[phone]
Keytis NS4RTS
fi 2
(fi 1) until the LED
the receiver blinks and
On the receiver circuit board, press on the arrows until you et to the position P.8 on the
onds to the open/close
Simultaneously press the button you wish to pro ram on your new remote control and the +
Two dashes appear on the screen. Let the buttons

http://www.remotecontrol-
express.com
Receiver type Passeo (fi .3) :
1. Place
your new remote control on the tar et raved on the hood of your receiver.
located next to your motor.
2.
Press the button you wish to pro ram on your new remote control.
3.
The LED li ht on the receiver blinks.
4. Wait 10 seconds.
5.
Your new remote control is pro rammed.
Programming Manual
express.com
- TEL : [phone] - FAX :
[phone]
fi 3
your new remote control on the tar et raved on the hood of your receiver.
located next to your motor.
Press the button you wish to pro ram on your new remote control.
Keep
The LED li ht on the receiver blinks.
Release the button.
Your new remote control is pro rammed.
[phone]
your new remote control on the tar et raved on the hood of your receiver.
It is
Keep
it pressed down.