SSV Works BR-2B65U User manual

PARTS LIST IMAGES
TOOLS NEEDED FOR INSTALLATION
BR-2B65U
2021+ Ford Bronco, 2 Door
6.5” Rear Speaker-Pod Add-Ons
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against
defects in material or workmanship. All SSV Works Electronics are covered by a
limited 1 year warranty against defects in material or workmanship. All Kicker
Speakers are covered by a limited 1 year warranty against defects in material or
workmanship. All Kicker Amplifiers are covered by a limited 2 year warranty
against defects in material or workmanship. Labor for replacement of defective
components is not covered. Contact SSV Works for further warranty
information.
Please read and understand these
instructions completely before installation to
avoid possible injury, or damage to the
accessory or vehicle.
!
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
(x2) M6 x Screw
Passenger Rear Door Pod Bracket Pack Driver Rear Door Pod
(x2) M6 Washer
•T25, T30 Torx Driver
•#1 Phillips Screwdriver
(x2) #1 Phillips Screw
BR-2B65U 2023 SSV Works, Oxnard, Ca 93030 BR-2BR65 Rev. A. 4-24-23

A. Remove the screw located at the bottom of the speaker
enclosure.
A
B. Removing the two screws securing the bracket to the
vehicle. Then remove the two screws securing the bracket to the
enclosure.
Note: These 4 factory screws will be re-used for the SSV pods.
*This image is of passenger side .
B
A. Secure the drivers side bracket to the driver side pod using
the factory two screws.
AB
CD
B. Hold the pod up near its mounting location and connect the
factory harness.
C. Snap the speaker pod harness cover onto the pod making sure
the harness exits the cover through one of the two reliefs.
D. Use the provided Philips screw to secure the cover in place.
BR-2B65U 2023 SSV Works, Oxnard, Ca 93030 BR-2BR65 Rev. A. 4-24-23

E. Loosely assemble the bottom of the pod to the frame of the
vehicle using the provided M6 screw and washer.
G. Fully tighten the bottom screw located at the bottom of the
pod.
EF
F. Install the two-factory bolts securing the pod to the vehicle.
Note: Image is of passenger side.
G
Repeat all steps for the opposite side.
BR-2B65U 2023 SSV Works, Oxnard, Ca 93030 BR-2BR65 Rev. A. 4-24-23