SSV Works SS-B65 User manual

SS-B65
Polaris Slingshot
Behind Seat 6.5” Speaker Pod
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against
defects in material or workmanship. All SSV Works Electronics are covered by
a limited 1 year warranty against defects in material or workmanship. All SSV
Works Speakers are covered by a limited 1 year warranty against defects in
material or workmanship. Labor for replacement of defective components is
not covered. Contact SSV Works for further warranty information.
TOOLS NEEDED FOR INSTALLATION
- T25 Torx driver - T40 Torx driver - 2.5mm Hex driver - 5/8” Drillbit
A. Use a T25 Torx driver to remove upper screws from the headrest
frame (2 places).
C. Use a 2.5mm hex driver to remove screws from the front of the
headrest pod (2 places).
B. Use a T40 Torx driver to Remove lower screws from the headrest
frame (4 places). Remove headrest frame.
D. Unscrew and remove gas cap and gas cap nut (driver side only).
A
C
B
D

G. Insert the rear tab of the speaker pod into the notch on the vehicle,
then lower into place
E. Remove the headrest by lifting from the front
H. Re-install gas cap nut (driver side only). Re-install gas cap (driver
side only). Re-install screws in the front of the speaker pod (2 places).
Re-install headrest frame.
F. Drill an opening for the speaker pod harness in location shown
SS-B65
G
E
H
F
© 2016 SSV Works, Oxnard, CA 93030 SS-B65 Rev. A 12-29-16
For proper sound, ensure the speaker polarity is correct connect the “+” to the “+” and the “-“to the “-“from the speaker wire to the amplier. If using
with an SSV Works complete system refer to the amplier wiring instructions for more detailed wiring information.
WIRING INSTRUCTIONS
“+”
“+”
“
- ”
“
- ”
Amplier