SSV Works RZ5-DF65 User manual

RZ5-DF65
2019+ Polaris RZR Pro XP
6.5” Front Door Speaker Pods
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material
or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against
defects in material or workmanship. All Kicker Speakers are covered by a limited 1 year
warranty against defects in material or workmanship. All Kicker Ampliers are covered by a
limited 2 year warranty against defects in material or workmanship. Labor for replacement of
defective components is not covered. Contact SSV Works for further warranty information.
TOOLS NEEDED FOR INSTALLATION
PARTS LIST IMAGES
2. M6 x 14mm Screws x 8 3. M6 Washers x 16
4. M6 x 16mm Screws & M6 Nuts x 4 5. Mounting Brackets x 2
1. RZ5-DF65 Enclosure (pair)
- T25, T30, T40 Torx Driver - 10mm wrench

C. Remove the (11) T40 torx screws and (2) T25 Torx screws from the door and set the door skin aside (Step C1). Put the pod in place on inside of the door.
Loosely fasten (2) T30 M6x1.0x14mm torx screw and washers through the top of the door frame and into the RZ5-DF65 (Step C2 & C3).
B. The mounting brackets are side specic. To verify the correct orientation of the bracket, follow the outline in the diagram above.
C2 C3
B1 B2
A. Fasten the mounting brackets to the enclosures with (2) T30 M6x1.0x14mm screws and washers.
A1 A2
DRIVER
DRIVER PASSENGER
PASSENGER
TOP
TOPTOP TOPTOP
BOTTOMBOTTOM BOTTOMBOTTOM
TOP
STRAIGHTSTRAIGHT
STRAIGHTSTRAIGHT
ANGLEDANGLED
ANGLEDANGLED
BOTTOM BOTTOM
RZ5-DF65
C1

E. Insert (2) T30 M6x1.0x16mm torx screws and washers through the front of the enclosure mounting bracket and
secure to the door frame with (2) 10mm M6 nuts and washers. Tighten hardware once it has all been installed.
E1 E2
WIRING INSTRUCTIONS
For proper sound, ensure the speaker polarity is correct connect the “+” to the “+” and the “-“to the “-“from the speaker wire to the amplier. If using
with an SSV Works complete system refer to the amplier wiring instructions for more detailed wiring information.
Installation is now complete. Re-assemble all door factory panels.
“+”
“+” “
- ”
“ - ”Amplier
© 2020 SSV Works, Oxnard, CA 93030 RZ5-DF65 Rev. A 1-28-20 RZ5-DF65