SSV Works WP-WC2O4 User manual

WP-WC2O4
Arctic Cat Wildcat Trail / Sport
4 Speaker Overhead
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: [phone] | Fax: [phone]
!
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material
or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against
defects in material or workmanship. All SSV Works Speakers are covered by a limited 1 year
warranty against defects in material or workmanship. Labor for replacement of defective
components is not covered. Contact SSV Works for further warranty information.
1. WP-WC204 x 1
2. M6 x 1.0 Screws x 16
3. M6 Washers x 16
4. Straight Mounting
Brackets x 2
TOOLS NEEDED FOR INSTALLATION
INSTALLATION NOTES
PARTS LIST
PARTS LIST IMAGES
5. Curved Mounting
Brackets x 2
6. Fuse Holder with Fuse
7. Crimp on ring terminal
8. Zip Ties
To make wiring easier, locate the battery in the vehicle before beginning the installation. The use of a thread locker is recommended on all screws
to prevent loosening due to vibration.
1. WP-WC204
5. Mounting Brackets x 2 6. Fuse Holder with Fuse
2. M6 x 1.0 Screws x 16
7. Crimp on ring terminal
3. M6 Washers x 16
8. Zip Ties
4. Mounting Brackets x 2
- Wire Crimpers
- Wire Strippers
- Wrench for Battery Terminal
- #3 Phillips Screwdriver

A. With one person on either side of the vehicle place the WP-
WC2O4 into location from the underside of the cage, place the
back into position rst, and then swing the front up into place.
A. Cut the power/ground cable to length; be sure to
leave enough wire at the battery location to wire to
the battery, strip back approximately 4 inches of the
black tubing to expose the red/black wires inside.
Strip back 1/4”-1/2” of wire to make your
connections.
B. Crimp the supplied
fuse holder onto the
end of the RED wire
and attach to the
battery “+” terminal.
C. Crimp the supplied
ring terminal to
the BLACK wire
and attach to the
battery “-” terminal.
C. Once the enclosure is in position, tighten the brackets using
the #3 screwdriver. NOTE: After all brackets are tightened,
it may be necessary to go back and re-adjust the brackets to
ensure the enclosure is properly secured.
D. Using the zip ties provided, route the Power/Ground loom
to the battery location away from any moving parts or sharp
metal. NOTE: The 4 pin long cable is an audio output for
adding an additional amplier and speakers.
B. While holding the enclosure securely to the underside of the
cage, loosely install the 5 brackets using the screws provided,
attaching the front brackets rst will help support the enclosure
while attaching the other brackets
WP-WC2O4
WIRING INSTRUCTIONS
INSTALLATION INSTRUCTIONS
A
A
B C
B
C D
© 2016 SSV Works, Oxnard, CA 93030 WP-C2M04 Rev. A 4-28-16