Streetwize SWGH3 User manual

Phone Holder
1
2
3
Will fit smartphones between
49mm & 82mm wide.
Intention for Use
This product is intended for ONLY holding smartphones only between
the width of 49mm to 82mm. This gadget holder can be mounted in
three different ways: vent-clip mount, dashboard mount &
windscreen suction mount.
To get the best use of this product, we advise that you read all
information in this document.
Product Elements
1. Streetwize Universal Car Smartphone Holder
(with attached suction mount)
2. Adhesive pad for dashboard mount
3. Vent-clip mount
Never position the phone holder in a place that obscures the
view of the driver.

Mounting the gadget holder
As mentioned, this product
can be mounted in three
different ways. Please follow the
instructions for your preferred
mounting option.
1.Windscreen Suction Mount
The windscreen suction mount
option already comes attached
out-of-the-box. To use this
option, simply unfold the gadget
holder as shown in Figure 1.
Mount the suction cup to your
windscreen. Ensure the gadget
holder is unfolding towards
you and not facing downwards
towards the windscreen. Secure
the suction mount in place by
turning the knob behind the
suction cup clockwise (see
Figure 2).
Then place your phone into the
adjustable grip (Figure 3). The
support arms are spring loaded,
simply pull apart to the required
width of your phone and adjust
the angle to your requirements.
With the suction mount, you
can rotate the device to view
your device either horizontally
or vertically.
To remove the suction mount
from your windscreen, simply
turn the knob anti-clockwise
and pull one of the tabs on the
suction cup.
Fig 1
Fig 2
Fig 3

2. Dashboard Adhesive Mount
To mount the gadget to your
dashboard, remove the adhesive
protection film from the supplied
pad (Fig 4) and position it on to
the suction pad of the phone
holder.
Position the holder as required
on the dash board (Fig 5). To
secure in place, screw the phone
holder to the dash using the
three screw holes (screws NOT
supplied).
Then place your phone into the
adjustable grip and adjust as
required.
3. Vent-Mount Clip: Please
note, the phone holder will not
rotate when using the vent-clip.
You will need to remove the
suction cup mount from the
phone holder. Hold the device as
per Figure 6 and position your
thumbs behind the adjustable
arm of the holder. Push your
thumbs forward until you hear
a click, the suction cup can
now be removed.
Fig 4
Fig 4
Fig 5

Assemble the vent clip by
positioning the vent grips(3) as
shown in Figure 6A. Simply place
the attachment end of the vent
clip through the hole in the
middle and slide either left or
right (Figure 6B).
Then attach the vent clip to the
gadget holder (Figure 7).
Using the vent-clip mount, place
the gadget holder on to your
vehicle’s vent. Ensure the vent
clip is secured around the vent
bars and the hinged bottom
support should be secured into
one of the vent bars at the
bottom as shown in (Figure 8)
9).
Mount your phone horizontally.
Manufacturer’s Warranty
This product comes with a 12
month manufacturer warranty
which starts on the date of
purchase. For any warranty
queries, please contact the
retailer where you purchased
the product.
Streetwize Accessories
Manchester M17 1RY
Tel: [phone]
www.streetwizeaccessories.com
Fig 8
Fig 6B
Fig 6A
Fig 7