
www.stryker.com 1061-090-001 REV H 7
RAIDING AND LOWERING LITTER HEIGHT - SIDE CONTROL/UNI-LOWER PEDAL
CAUTION
Be sure to move any equipment that may be in the way before raising or lowering the litter height.
To raise the litter height, pump pedal (A) repeatedly until the desired height is achieved (see illustration under
Operating Base Controsl section).
To lower both ends of the litter together, depress the center of pedal (B). To lower only the head end of the litter,
depress the side of pedal (B) closest to the head end.
To lower only the foot end of the litter, depress the side of pedal (B) closest to the foot end (see illustration under
Operating Base Controls section).
The base may be equipped with optional variable descent controls. With variable descent controls, the farther you
press down on the pedal, the faster the litter will lower.
TRENDELENBURG/REVERSE TRENDELENBURG - SIDE CONTROL/UNI-LOWER PEDAL
NOTE
Litter height must be raised first in order to achieve a trend. or reverse trend. position.
CAUTION
Be sure to remove any equipment that may be in the way before lowering stretcher.
For Trendelenburg positioning (head down), depress the side of pedal (B) closest to the head end of the stretcher
(see illustration under Operating Base Controls section).
For Reverse Trendelenburg positioning (foot down), depress the side of pedal (B) closest to the foot end.
NOTE
The higher the litter is before pedal (B) is activated, the greater the trend. or reverse trend. angle will be. (Maximum
trend. angle is +18°. Maximum reverse trend. angle is –18°.)
APPLYING THE BRAKE SYSTEM
NOTE
For user convenience, the brake/steer pedal is located at the head end and on both sides of the stretcher.
WARNING
Always apply the caster brakes when a patient is getting on or off the stretcher. Push on the stretcher to ensure the
brakes are securely locked. Always engage the brakes unless the stretcher is being moved. Injury could result if the
stretcher moves while a patient is getting on or off the stretcher.
To engage the brakes at the head end of the stretcher, push fully down on the left side of pedal (G) (see illustration
under Operating Base Control section).
To engage the brakes at the patient, right side of the stretcher, push fully down on the right side of pedal (F) (see
illustration under Operating Base Control section).
To engage the brakes at the patient, left side of the stretcher, push fully down on the left side of pedal (E) (see il-
lustration under Operating Base Control section).
•
•
•
•
Stretcher Operations
Return To Table of Contents