superbrightleds EL2-CRW User manual

LED Emergency Light
EL2-CRW
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Specications
EL2-CRW
Operating Temperature 32°–104° F (0°–40° C)
Fixture Weight 0.8 lb (350 g)
Battery Type Ni-Cd (3.6 V / 900 mAh)
User Manual
EL2-CRW
¹
¹Limited 2-year warranty on battery.
Rev Date: V1 05/04/2021
Testing
Manual Test
Test button can be held to illuminate lights for manual testing purposes.
Wiring Diagram
Important: Read all instructions prior to installation. SAVE THESE INSTRUCTIONS.
Warning
Cautions
Read and follow all safety instructions. When using electrical
equipment, basic safety precautions should always be followed
including the following:
• Disconnect power at fuse or circuit breaker before installing
or servicing.
• Do not use outdoors.
• Do not mount in hazardous locations or near gas or electric
heaters.
• Do not let power cords touch hot surfaces.
• Equipment should be mounted at heights and locations
where it is not subjected to tampering by unauthorized
personnel.
• The use of accessory equipment is not recommended.
• Do not use this equipment other than its intended use.
• All services should be performed by qualied personnel.
• Allow battery to charge for 24 hours before rst use.
Maintenance
• Not required. Replace the batteries as needed according
to ambient conditions. We recommend the equipment be
tested regularly in accordance with local codes.
Operation
• Press the test button, the LED heads will turn on and the
LED indicator will turn o󰀨.
• Release the test switch, LED indicator will turn on and the
LED heads will turn o󰀨.
Troubleshooting
• Check AC supply, verify the unit has 24 hours of AC supply
before emergency use.
• Verify the unit is shorted or battery is not connected
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Battery
LED 2
LED 1
AC ON TEST
277 VAC
120 VAC
N
-
-
+
+
-
+
LED
LED

Installation Instructions
1. Carefully remove mounting plate by using the release
buttons.
2. Remove appropriate knockouts for wiring and mounting
from rear panel.
3. Run wiring through mounting plate and connect
wiring to junction box. Cap unused wire.
(refer to wiring diagram)
Note: Red and black wires should
never be connected at the same time.
4. Securely attach mounting plate to surface
or junction box with hardware.
5. Connect battery to board.
6. Reattach light assembly to mounting
plate.
7. Apply power and allow battery pack to charge for at
least 24 hours before initial use/test.
8. After 24-hour period, press test button to make
certain lights are functioning as intended.
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
LED Emergency Light
Important: Read all instructions prior to installation. EL2-CRW
User Manual
¹
¹Limited 2-year warranty on battery.
Rev Date: V1 05/04/2021
Battery