Surveon SMR5000 Series User manual

1
SMR2000/5000 Installation SOP
Surveon Technical Support Team
Revision 1.0

Revision History
Version
Description
1.0
Initial document
2

3
Requirements for installing Surveon Megapixel Solutions
Requirement Check
Network Knowledge X
IP / Network Configuration Skill X
PC Server Configuration Skill X
Follow the SOP O

4
Outline
Steps Topic Notes
1 Get Your Fixture / Tool Ready
2 Pick a Project Topology
3 Pre-Configure the NVR at office
4 Simulate the E2E equipment at office
5 Field Side Installation
6 FAQ and Troubleshooting

5
Step 1: Get Your Set Up Environment
Ready

6
Check List for a “Surveon LAB”
Item Requirement Notes Check
1 Network port with Internet Access Home or office
network
2 16+ Port POE Switch 15.4 W per port 802.3AF POE
3 PC with IP Utility, Team viewer Download
4 LCD Monitor (VGA / DVI) For NVR
5 Ethernet UTP Cables For LAB
6 Portable Monitor with Composite Input ON site use

Surveon LAB topology
Per Project
Equipment
Office PC
Surveon LAB PC
Office LAN Broadband Router
POE Switch for the Project will be tested out of this LAN
7
Or

8
Step 2: Pick a Topology for your Project

9
Check List for a Surveon LAB
Item Topology Local
Monitor
Remote
Monitor
Monitor from
Internet/Home
A1 Basic Standalone Y X X
A2 Standalone with Expansion Switches Y X X
A3 Standalone + Remote Client Y Y X

10
A1 : Basic Standalone Architecture
Notes: The IP Address is for reference only

11
A2 : Multiple Locations/Channels
Notes: The IP Address is for reference only

12
A3 : Standalone with Remote Monitoring
For the Internet Access need to go
through the Appendix D for the
advanced setting.

13
Step 3: Pre Configure NVR at office

14
Steps 3 for Pre Configure the NVR
Steps Actions Target
3-1 Connecting NVR to the LAB and
Preinstall HDD Get NVR ready for setup
3-2 Built the Storage RAID Creation
3-3 Initialize the System
Install system to RAID
Resolution
Time
Account
Scan camera

15
Step 3-1-1 : Connect the NVR to the LAB
1. Connect the KB, Mouse & Monitor
2. Connect the LAN(only one port) to the LAB’s POE Switch (any port)
3. The LAB’s POE switch should be connected to DHCP server.

16
Step 3-1-2 : Install the Hard Drives
Notes: Make sure you use Surveon Qualify HDD
http://www.surveon.com/support/hardware.asp .
1. Put the qualify HDD on the HDD Tray
2 Insert the HDD to the SMR/NVR

17
Step 3-1-3 : Boot up the NVR
1. Make sure you connect the KB, Mouse, Monitor
2. Click the power button
3. You will see the log in page live below
Client Version Name

Step 3-1-3 : Boot up the NVR
18
If boot up the SMR and see this pop-up dialog, please press NO
button to skip this step.

19
Step 3-1-4 : Login to the NVR/SMR
•Follow Below to log in to the SMR/NVR
•Username: admin
•Password: admin
•Type: VMS (keep default)
•Server: SMRServer -127.0.0.1 (keep default)

20
Step 3-1-5 : Initialization Page
•For the 1st boot the system, You will see the initialize screen once
you log in.
•Press the next to move to Step 2