Symmons Dia 353SR-5 Manual

Dia®
Model Numbers Specification
353SR-5, 353SR-6
Curved Shower Rod
Operation & Maintenance Manual
☐353SR-5 5' Curved Shower Rod
☐353SR-6 6' Curved Shower Rod
Dimensions & Tools Required
Measurements
A60", 1524 mm (353SR-5)
72", 1829 mm (353SR-6)
B 2-1/8", 54 mm
C 10-1/2", 267 mm
Note: Dimensions subject to change without notice.
Finish Options
Limited Lifetime - to the original end purchaser in
consumer/residential installations.
5 Years - for industrial/commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Warranty
Note: Append appropriate -sufx to model number.
☐-STN Satin Nickel finish
• Curved shower rod
• Metal construction
AA
B
B
CC
For 60" Standard Tub
Mount rod approximately 3" inside the point a
straight rod is normally mounted. The midpoint
of the rod should extend several inches past the
outside rim of the tub.
For 60" Oval Tub
Depending upon tub model, mount rod between
6" and 8" from centerline of the tub. The middle
portion of the rod should curve just outside the
contour of the tub.
Tools Required
Drill:
3/8 inch for studs
1/4 inch for drywall
5/16 inch for tile
Pencil
Phillips Head
Screwdriver
Safety Glasses
Stud Finder

For California Residents
WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
Symmons Industries, Inc. ■31 Brooks Drive ■Braintree, MA 02184 ■Phone: [phone] ■ Fax: [phone]
Copyright © 2017 Symmons Industries, Inc. ■symmons.com ■[email protected] ■ZV-3015 REV D ■ 112717
Troubleshooting
Problem Cause Solution
Finish is spotting. Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then quickly
rinse with water.
Installation
1) Position mounting brackets into
desired location. Mark hole positions
with pencil.
3) With mounting brackets in position,
secure to wall using screws.
4) Insert rod brackets into mounting
brackets and secure with Allen
screws.
1
5) Insert shower rod into rod brackets
and secure with Allen screws.
2b) Dry Wall Option: Carefully drill
1/4" holes into wall. Install drywall
anchors into holes.
2a) Stud Option: Carefully drill 3/16"
holes through wall and up to studs.
2
2
1
2c) Tile Option: Carefully drill 5/16"
holes into tile. Install tile anchors
into holes.
2
2
1