Tait TP2210-H5 User manual

DMR Two Way Radio
TP2210-H5

Instruction Manual Instruction Manual
DMR Two Way Radio
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio
TP2210-H5 DMR Two Way Radio
TP2210-H5 DMR Two Way Radio
TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

Instruction Manual Instruction Manual
FCC Warning:
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
TP2210-H5 DMR Two Way Radio TP2210-H5 DMR Two Way Radio

This product meets the applicable Industry Canada technical
specifications. / Le présent matériel est conforme aux specifications
techniques applicables d’Industrie Canada.
1. This product is limited to occupational applications that can meet
RF energy radiation requirements. The user must be fully aware of
the RF radiation hazards and can take corresponding measures to
meet the RF radiation limitation requirements.
2. Radio frequency (RF) refers to the electromagnetic frequency that
can be radiated into space. It is a widely used technology in the
fields of communication, medical treatment, and food processing. It
will generate certain RF radiation during use.
RF Radiation Information
Safety Information
In order to use the radio safely and efficiently, please read the following
safety information:
·The radio can only be maintained by professional technicians. Do not
disassemble the radio without permission.
·Only the batteries and chargers specified by our company can be
used.
·To avoid problems caused by electromagnetic interference and
electromagnetic compatibility, please turn off the radio in places
where the "Please turn off the radio" sign is displayed, such as
hospitals and other health care places. When taking the flight, please
turn off the radio if the crew requests to do so.
·In vehicles with airbags, do not place the radio in the area where airbag deployment may be
involved.
·Please turn off the radio before entering flammable or explosive environment.
·Do not replace or charge the battery in a flammable or explosive environment.
·Please turn off the radio before approaching the blasting area and the detonator area.
·Do not use the radio with damaged antenna. A damaged antenna may cause minor burns
when it comes into contact with the skin.
·Do not expose the radio to direct sunlight for a long time or place it near the heating Radio.
·If you wear a portable radio, make sure the antenna is at least 2.5 cm away from your body
when the radio is transmitting.
IC Warning：This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation
is subject to the following two conditions:
1. This device may not cause interference. 2. This device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil contient un ou des émetteurs/récepteurs exempts de licence conformes aux
RSS exempts de licence d’Innovation, Sciences et Développement économique Canada. Le
fonctionnement est soumis aux deux conditions suivantes :ＨＱＩ＠ｬﾒ｡ｰｰ｡ｲ･ｩｬ＠ｮ･､ｯｩｴ＠ｰ｡ｳ＠
ｰｲｯ､ｵｩｲ･＠､･＠｢ｲｯｵｩｬｬ｡ｧ･Ｌ＠･ｴ＠ＨＲＩ＠ｬﾒｵｴｩｬｩｳ｡ｴ･ｵｲ＠､･＠ｬﾒ｡ｰｰ｡ｲ･ｩｬ＠､ｯｩｴ＠｡｣｣･ｰｴ･ｲ＠ｴｯｵｴ＠｢ｲｯｵｩｬｬ｡ｧ･＠
ｲ｡､ｩｯ￩ｬ･｣ｴｲｩｱｵ･＠ｳｵ｢ｩＬ＠ｭ￪ｭ･＠ｳｩ＠ｬ･＠｢ｲｯｵｩｬｬ｡ｧ･＠･ｳｴ＠ｳｵｳ｣･ｰｴｩ｢ｬ･＠､ﾒ･ｮ＠｣ｯｭｰｲｯｭ･ｴｴｲ･＠ｬ･＠
ｦｯｮ｣ｴｩｯｮｮ･ｭ･ｮｴＮ
该文档是极速PDF编辑器生成，如果想去掉该提示,请访问并下载：http://www.jisupdfeditor.com/

RF Exposure Compliance and Control Guidelines and Operating Instructions
To control your exposure and ensure compliance with the occupational/controlled
environment exposure limits always adhere to the following procedures.
Guidelines:
. Do not remove the RF Exposure Label from the device.
. User awareness instructions should accompany device when transferred to other users.
.Do not use this device if the operational requirements described herein are not met.
Operating Instructions:
. Transmit no more than the rated duty factor of 50% of the time. To transmit (talk),
push the Push-To-Talk (PTT) button. To receive calls, release the PTT button.
Transmitting 50 % of the time, or less, is important because this radio generates
measurable RF energy exposure only when transmitting (in terms of measuring for standards compliance).
. Hold the radio in a vertical position in front of face with the microphone
(and the other parts of the radio, including the antenna) at least one inch (2.5 cm)
away from the nose.Keeping the radio at the proper distance is important because
RF exposures decrease with distance from the antenna. Antenna should be kept
away from eyes.
. When worn on the body, always place the radio in approved clip, holder,
holster, case, or body harness for this product. Use of non-approved accessories
may result in exposure levels, which exceed the occupational/controlled environment
RF exposure limits.
may exceed the FCC and IC RF exposure guidelines.
. For a list approved accessories please consult your local dealer for information.
. Use only manufacturer’s name approved supplied or replacement antennas,
batteries, and accessories. Use of non-manufacturer-name approved antennas,
batteries, and accessories may exceed the FCC and IC RF exposure guidelines.
RF Exposure Compliance and Control Guidelines and Operating Instructions

Pour contrôler votre exposition et garantir le respect des limites d'exposition en milieu
professionnel / contrôlé, respectez toujours les procédures suivantes.
Des lignes directrices:
• Ne retirez pas l'étiquette d'exposition RF de l'appareil.
• Les instructions de sensibilisation de l'utilisateur doivent accompagner l'appareil lorsqu'il est
transféré à d'autres utilisateurs.
• N'utilisez pas cet appareil si les exigences opérationnelles décrites ici ne sont pas satisfaites.
Mode d'emploi:
• Ne transmettez pas plus que le facteur de service nominal de 50% du temps. Pour transmettre
(parler), appuyez sur le bouton Push-To-Talk (PTT). Pour recevoir des appels, relâchez le
bouton PTT. La transmission à 50% du temps, ou moins, est importante car cette radio génère
une exposition à l'énergie RF mesurable uniquement lors de la transmission (en termes de
mesure de conformité aux normes).
• Tenez la radio en position verticale devant le visage avec le microphone (et les autres parties
de la radio, y compris l'antenne) à au moins 2,5 cm (2,5 cm) du nez. Il est important de garder la
radio à la bonne distance car les expositions aux RF diminuent avec la distance de l'antenne.
L'antenne doit être éloignée des yeux.
• Lorsqu'elle est portée sur le corps, placez toujours la radio dans un clip, un support, un étui, un
étui ou un harnais de sécurité approuvés pour ce produit. L'utilisation d'accessoires non
approuvés peut entraîner des niveaux d'exposition qui dépassent les limites d'exposition aux RF
de l'environnement professionnel / contrôlé.
• Utilisez uniquement les antennes, batteries et accessoires fournis ou de remplacement
approuvés par le fabricant. L'utilisation d'antennes, de batteries et d'accessoires non approuvés
par le fabricant peut dépasser les directives d'exposition RF FCC et IC.
• Pour obtenir une liste des accessoires approuvés, veuillez consulter votre revendeur local pour
plus d'informations.