Tally Dascom 7010 User manual

Installation Guide 7010 Peeler Unit
This guide is provided for use by service representatives who must install the
peeler unit. If the peeler is not installed, please contact your supplier.
(1) Check to make sure that the printer's power switch is turned off then disconnect the
power cord.
(2) Open the top cover and lift the thermal printhead and sensor arm.
(3) Remove the operation panel on
the front of the printer (2 screws).
When doing this, remove the
flexible cable that is connected
to the operation panel.
(4) Remove the front right cover on
the front of the printer. (2 screws)
Head open lever Sensor arm open lever
Thermal printhead
Flexible cable
Sensor arm
Top cover
Operation
panel
Front right
cover
Note Installation requires a cross-point ('Phillips') screwdriver with magnetic tip and a
shaft at least 200 mm (8 inches) long.
Caution

(6) Remove the plastic cover from the front center cover that you have removed.
(2 screws)
Note The plastic cover that you have removed is needed if the peeler unit is
de-installed, so store it carefully.
(7) Attach the peel guide plate to the front center cover taking care not to over-tighten
the screws as they are threaded in plastic. (2 screws)
(5) Remove the front center cover. (2 screws)
Plastic cover
Peel guide plate
Front center cover

Release knob
Peeler unit
Alignment holes and pins
(8) Attach the connector of the peeler unit to the daughter board as shown in the figure.
Note The connector cannot be connected if it is inserted in the wrong orientation
unless force is used!
Check the orientation of the connector carefully.
(9) Slide the release knob of the peeler unit to the left and open the peeler unit.
Daughter board
Connector
(10) After positioning the peeler unit on the printer using the alignment pins on the peeler
as a guide, fix the unit to the printer using the screw supplied. Then close the peeler.
Note Be careful not to pinch the wiring harness from the peeler unit.
Wiring harness

©
Copyright DASCOM Europe GmbH v1.0
(12) Attach the front right cover removed at step 4 in its original position. (2 screws)
(13) Attach the operation panel removed at step 3 in its original position. (3 screws)
Note Be sure to connect the flexible cable that you disconnected as it was
formerly connected. The blue side of the tip is upwards.
(14) Close the top cover.
(15) Connect the power cord and turn on the power switch on the printer.
Note Removing the peeler unit
To remove the peeler unit from the printer, follow the installation steps in
reverse order. If the screws that fasten the peeler unit are removed, the unit
may fall from the printer, so hold the peeler unit with your hand while
loosening the fastening screws.
(11) Align the two tabs on the bottom of the 'front center cover' to the slits of the printer as
it is slid in to the printer. The bottom plate of the front cover needs to be held up from
below to ensure a good fit. Attach the front center cover from step 5 in its original
position. (3 screws, of which 1 is an accessory to the unit)
Alignment "pin"
Slit
Alignment hole
Front center cover