Tamerica TCC-1655HC User manual

support beam
Left leg assembly
Right leg assembly

Insert the supplied allen screw through the holes to attach the support beam into one side of the stand.
Repeat the process on the other side. Fully tighten with allen key only after all screws have been properly
aligned and inserted.

Before securing the laminator on the stand, take note: the shorter span would be
facing front while the longer span would be facing the rear.
Longer rear
Shorter front

Insert the supplied phillips screw through the holes
to secure the laminator onto the stand. There are 4 on each side.

This is the view from the bottom left hand side. You will notice the base of the stand protruding by about 3/8”.

Here’s another view from the above. Notice the 2 screws already attached to the base of the stand from
Factory.
Stand base protrudes by about 3/8”

Attach the bracket on the right hand side of the machine by securing
with provided screws.

Here’s another view facing the right hand side of the machine.