T&D TR71A User manual

Regarding the Use of Wireless Devices (TR71A, TR72A, TR-75wb)
Precautions when Installing Wireless Communication DevicesPhysical Objects:Placing wireless devices far from each other and/or near to obstacles (such as metal objects, concrete, plants, etc.) may lead to a poor wireless connection.Electrical Interference:Placed near cooking equipment such as microwave ovens or communication devices that generate electromagnetic waves. Access Point Capacity:Having many devices connected to one access point simultane-ously.Regarding how many wireless devices can simultaneously connect to an
access point and still maintain stable connections, please contact the
manufacturer of the wireless access point. Channel Congestion:Using multiple wireless LAN access points with the same communication frequency channel.Change the wireless LAN access point settings to assign a non-overlap-
ping channel to each access point.
Note: If unstable wireless connection continues, not only will more data transmission errors occur, but battery life will also be shortened.
電波に関するご注意Bluetooth low energy・無線LAN の電波に関して電波の種類と干渉距離 Bluetooth low energy 無線 LAN(IEEE 802.11b/g/n)

Compliance Information
For TR71A / TR72A / TR-75wb<For FCC Model>FCC StatementThis device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Responsible Party:
CAS Dataloggers
Chesterland, Ohio
https://www.dataloggerinc.com/
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
ISED StatementThis device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions: 1.
This device may not cause interference. 2. This device must accept any
interference, including interference that may cause undesired operation
of the device.
This digital apparatus complies with CAN ICES-3(B)/NMB-3(B).
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : 1. L’appareil ne doit pas produire de
brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
FCC/ISED Radiation Exposure StatementThis equipment complies with FCC/ISED radiation exposure limits set
forth for an uncontrolled environment and meets the FCC radio fre-
quency (RF) Exposure Guidelines and RSS-102 of the ISED radio frequency
(RF) Exposure rules. This equipment should be installed and operated
keeping the radiator at least 20cm or more away from person’s body.
This transmitter must not be co-located or operated in conjunction with
any other antenna or transmitter.
Cet équipement est conforme aux limites d’exposition aux rayonnements
énoncées pour un environnement non contrôlé et respecte les règles les
radioélectriques (RF) de la FCC lignes directrices d’exposition et d’exposition
aux fréquences radioélectriques (RF) CNR-102 de l’ISDE. Cet équipement doit
être installé et utilisé en gardant une distance de 20 cm ou plus entre le radia-
teur et le corps humain.
Location of FCC ID and IC Certication NumberThe FCC ID and IC ID can be found inside the battery compartment of
your device. <For CE Model>CE StatementHereby, T&D Corporation declares that this device is in compliance with
RE Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the follow-
ing internet address:
https://tandd.com/manual/pdf/doc-tr7a-series.pdf
https://tandd.com/manual/pdf/doc-tr7wb-series.pdf
<Important Notice>Wireless products cannot be used in countries other than where those
products have been approved for use, according to that country’s wire-
less regulations.
T&D Corporation shall in no manner whatsoever take responsibility for
the usage of these products, nor be liable in any manner for legal conse-
quences stemming from the usage of these wireless products in unap-
proved areas.
For TR-71nw / TR-72nw / TR-72nw-S / TR-75nw<For FCC Model>FCC StatementThis device complies with Part 15 of the Federal Communications Com-
mission (FCC) rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harm-
ful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To comply with the limits for the Class B digital device, pursuant to Part
15 of the FCC Rules, this device must be installed in computer equipment
certied to comply with the Class B limits.
All cables used to connect the computer and peripherals must be
shielded and grounded. Operation with non-certied computers or non-
shielded cables may result in interference to radio or television reception.
Caution: Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
ISED StatementThis digital apparatus complies with CAN ICES-3(B)/NMB-3(B).
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
<For CE Model>CE StatementHereby, T&D Corporation declares that this device is in compliance with
EMC Directive 2014/30/EU.
The full text of the EU declaration of conformity is available at the follow-
ing internet address:
https://tandd.com/manual/pdf/doc-tr7nw-series.pdf
tandd.com
2021.06 16708230003 (2nd Edition)
This manual suits for next models
2
Other T&D Data Logger manuals