TE Connectivity T3212 User manual

1
Do not connect the USB cable until you are
instructed to.
5
Install printer on PC.
Ne connectez pas le câble USB tant que vous
n’y êtes pas invité.
Installer l'imprimante sur PC.
Schließen Sie das USB-Kabel erst an, wenn Sie
dazu aufgefordet werden.
Drucker auf dem PC installieren.
Sluit de USB-kabel pas aan wanner dit in de
instructies wordt aangegeven.
Printer op pc installeren.
Non collegare il cavo USB fino a quando non
espreeamente richiesto.
Installa la stampante sul PC.
No conecte el cable USB hasta que se le
indique.
Instalar impresora en PC.
Ligue apenas o cabo USB quando isso lhe for
solicitado.
Instalar impressora no PC.
在您得到指示之前，请勿连接
USB 电缆
在电脑上安装打印机
2
Access Printer driver from TE.com.
6
Connect to your PC.
Accédez au pilote d'imprimante à partir de
TE.com.
Reliez l’appareil à votre PC.
Greifen Sie auf den Druckertreiber von TE.com
zu.
Ihren PC anschließen.
Open het printerstuurprogramma vanaf TE.com.
Aansluiten op uw pc.
Accedere al driver della stampante da TE.com.
Collegare al PC.
Acceda al controlador de la impresora desde
TE.com.
Conectar al ordenador.
Acesse o driver da impressora em TE.com.
Conectar ao PC.
从TE.com 访问打印机驱动程序。
连接到您的电脑
3
Install.
7
Loading path for ribbon.
Installer.
Chemin de chargement du ruban.
Installieren.
Farbband-Zuführungsweg.
Installere.
Laadpad voor lint.
Installare.
Percorso di caricamento del nastro.
Instalar.
Colocar el recorrido de la cinta.
Instalar.
Colocação da fita de impressão.
安装
加载碳带
4
Connect and plug in. Turn on.
8
Loading path for media.
Connectez et branchez. Merttez sous tension.
Chemin de chargement des
consommables.
Anschließen und einstecken. Einschalten.
Medien-Zuführungsweg.
Aasluiten en stekker in stopcontact. Inschakelen.
Laadpad voor media.
Connetterre e collegare alle presa. Accendere.
Percorso di caricamento del supporto
stampabile.
Conecte y enchufe. Encender.
Colocar el material a ser impreso.
Ligue à impressora e à corrente. Ligar
Colocação do material para impressão
连接及插入电源线。启动。
加载耗材

TE Connectivity, TE, TE Connectivity (logo) and Every Connection Counts are trademarks. All other logos, products and/or company names
referred to herein might be trademarks of their respective owners. The information given herein, including drawings, illustrations and schematics
which are intended for illustration purposes only, is believed to be reliable. However, TE Connectivity makes no warranties as to its accuracy or
completeness and disclaims any liability in connection with its use. TE Connectivity‘s obligations shall only be as set forth in TE Connectivity‘s
Standard Terms and Conditions of Sale for this product and in no case will TE Connectivity be liable for any incidental, indirect or consequential
damages arising out of the sale, resale, use or misuse of the product. Users of TE Connectivity products should make their own evaluation to
determine the suitability of each such product for the specific application.
The information contained within this document is the property of TE Connectivity. It is supplied in confidence and the commercial security of
the contents must be maintained. It must not be used for any purpose other than that for which it is supplied nor may any information contained
in it be disclosed to unauthorised persons. It must not be reproduced in whole or in part without obtaining written permission from TE
Connectivity (TE).
5375 (08/13)
411-121061
CLASS 1-Public
T3212 & T3224 Printer
Quick Start Guide
T3212 & T3224 Printer Warranty
The T3212 & T3224 Printers are warranted by TE Connectivity (TE) to be free
from defect in material and workmanship
Proof of purchase and delivery date is required to validate the warranty
period. The warranty becomes void if the equipment is modified, improperly
installed or used, damaged by accident or neglect, or if any parts are
improperly installed or replaced by the user.
NOTE: Products returned must be packaged in the original or
comparable packing. In the event equipment is not so packaged, or if
shipping damage is evident, it will not be accepted for service under
warranty. If TE Connectivity determines that the product returned for
warranty service or replacement is not defective as herein defined, the
customer will pay all handling and transportation costs.
Printers: All printers (excluding printheads) are warranted against defect in
material or workmanship for twenty-four (24) months from the delivery date.
Printheads: Since printhead wear is part of normal operation, the original
printhead is covered by 12 months from purchase or up to 1 million printed
idents (whichever comes first), using approved TE products and ribbons.
To qualify for this warranty, the printhead must be returned to TE
Connectivity. If it is determined that the use of non-approved or inferior
supplies has caused any defect in the printhead for which a warranty claim is
made, the user is responsible for TE Connectivity labour and material charges
required to repair the defect. Please refer to T3212 & T3224 technical
datasheet TTDS-272 & 274 and the latest issue of the Identification printer
product ribbon matrix (411-121005) for approved media. The warranty
becomes void if the printhead is physically worn or damaged; also, if it is
determined that failure to follow the preventive maintenance schedule listed in
the T3212 & T3224 Printer Operators Manual (412-121035) has caused
defect in the thermal printhead for which a warranty claim is made. TE
Connectivity recommends regular cleaning of the printhead in accordance
with Thermal Transfer printer cleaning instructions (411-121037).
The warranties given are the only warranties given to you. No other
warranties, express or implied, are given. TE Connectivity does not make any
implied warranty of merchantability or fitness for a particular purpose in
connection with its sale of products or services. While TE Connectivity desire
is to be responsive to your specific needs and questions, TE Connectivity
does not assume responsibility for any specific application to which any
Products are applied, including, but not limited to, compatibility with other
equipment. All statements, technical information, or recommendations relating
to TE Connectivity Products are based upon tests believed to be reliable, but
do not constitute a guaranty or warranty. TE Connectivity maximum liability for
warranty claims is limited to the invoice price of the Product claimed defective.
TE Connectivity does not assume responsibility for delays in replacement or
repair of products. TE Connectivity shall not under any circumstances
whatsoever be liable to you or any other party for loss or profits, lost data,
diminution of good will, or any other special or consequential damages
whatsoever with respect to any warranty claim made by you. Specifically for
software, TE Connectivity is not liable for any incidental or consequential
damages caused by abuse or misapplication of the software or by its use in
violation of the U.S. copyright law or international treaty.
No salesperson, representative, or agent of TE Connectivity is authorized to
make any guaranty, warranty, or representation that contradicts the foregoing.
Any waiver, alteration, addition, or modification to the foregoing warranties
must be in writing and signed by an executive officer of TE Connectivity to be
valid.
©2022 Tyco Electronics
Corporation, a TE
Connectivity Ltd. company
All Rights Reserved
| Indicates Change
Class I Data Classification - See Policy
TEC-02-04
Rev [3]
20 June 2022