TechNexion PIXI-9377 User manual

(
1
/5)
User sManual
Product:WiFi+Bluetooth4.1(HS)SystemonModule
Manufacturer:TechNexion Ltd.
Model: PIXI-9377
ForOriginalEquipmentManufacturerintegrationonly thisdevicecannot
be soldtothegeneralpublic
FCCID:2AKZA-QCA9377
IC:22364-QCA9377

(2/5)
GeneralSpecifications
Form Factor PIXI16mmx12mmx1.0mm Wireless SIPModule
MCU QualcommQCA9377-3
WLANIEEE802.11a/b/g/n/ac
Bluetooth Bluetooth4.1(+HS,BLE)
Frequency
Range
Bluetooth2.1 +EDR/4.1:2402MHz ~2480MHz
802.11b/g/nHT20MHz:2412MHz~2462MHz
802.11nHT40 MHz:2422MHz ~2452MHz
802.11a: 5180MHz~5240MHz /5745MHz~5825MHz
802.11nHT20 MHz:5180MHz ~5240MHz /5745 ~5825MHz
802.11nHT40 MHz:5190MHz ~5230MHz /5755 ~5795MHz
802.11ac VHT80 MHz:5210MHz /5775MHz
Antenna 1xMHF4 connector
HostInterface
WLAN:SDIO3.0
BT:UART/ I2S
Voltage InputsupplyforhostI/O:3.3V
SignalingWIFIcontrolfunctionthroughtoSDIOinterface
BTcontrolfunctionthroughto UARTinterface
Environment
Support
OperatingTemperature -40~85
StorageTemperature -40~135

(3/5)
UserManualwithStatement required
FCC Statement:
FCC 15.119:
This devicecomplieswithPart 15 ofFCCRules.Operation is Subjecttofollowingtwoconditions:
(1) Thisdevicemaynotcauseharmfulinterference,and
(2) Thisdevicemust accept anyinterferencereceivedincluding interferencethatcauseundesired
operation.
FCC 15.105:
This equipmenthasbeen testedand found tocomplywithinthe limits foraClass Bdigitaldevice,
pursuanttopart15of the FCCRules. Theselimits aredesignedtoprovide reasonable protection against
harmful interferenceinaresidentialinstallation.
This equipmentgenerates, uses, andcanradiateradiofrequencyenergyand,if not installedandusedin
accordancewiththe instructions, maycauseharmfulinterferencetoradiocommunications.However,
there isno guarantee that interferencewillnotoccur inaparticular installation. Ifthisequipmentdoes
causeharmfulinterferencetoradio or televisionreception,whichcanbedeterminedbyturning the
equipmentoff andon,theuserisencouragedtotrytocorrect the interferencebyoneor more ofthe
followingmeasures:
Reorient orrelocatethereceivingantenna
Increasetheseparationbetween theequipmentandreceiver
Connect theequipmentintoanoutlet onadifferentcircuitfromthattowhichthereceiverisconnected.
Consultthedealer oran experiencedradio/TVtechnicianforhelp.
lAnychangesor modificationsnotexpresslyapproved bythe partyresponsibleforcompliancecould
void the authoritytooperateequipment.
lThisequipmentcomplieswithFCC radiationexposurelimits setforthforan uncontrolled
environment.This equipmentshouldbe installed and operatedwith
minimumdistance20cmbetween theradiator &your body
ModularApproval
OEMINTEGRATIONINSTRUCTIONS:
This deviceisintendedonlyfor OEMintegratorsunderthe followingconditions: 1)The modulemustbe
installedinthe host equipment suchthat20cm ismaintained between theantenna andusers, and2)the
transmittermodule maynot be co-located withanyothertransmitterorantenna. Aslong as 2conditions
aboveare met, further transmittertest willnotberequired.However,theOEMintegrator is still
responsible for testingtheir end-productfor anyadditionalcompliancerequirementsrequired withthis
module installed (for example,digitaldeviceemissions, PCperipheralrequirements, etc.).
Anychanges or modifications notexpresslyapprovedbythe manufacturercouldvoidthe user's authority
tooperatethisequipment.
IMPORTANTNOTE:
Intheeventthat theseconditionscannotbemet(for examplecertain laptopconfigurations or co-location
withanother transmitter),thenthe FCC authorization forthis modulein combination withthe host
equipmentisnolonger considered valid andthe FCC ID ofthemodule cannotbeused on the final
product. Inthesecircumstances,the OEM integrator will be responsiblefor re-evaluatingtheend product
(includingthe transmitter)and obtaining aseparateFCC authorization.
USERSMANUAL OFTHEENDPRODUCT:
TheOEMintegrator has tobe aware not toprovide informationtotheend user regarding howtoinstallor
removethisRF modulein the user's manual oftheend product whichintegrates thismodule.Theend
usermanualshall include allrequiredregulatoryinformation/warningas showin this manual.
LABELOFTHEENDPRODUCT:
Thefinalendproduct must be labeledinavisible area withthefollowing "ContainsTXFCC ID:2AKZA-
QCA9377

(4/5)
ICStatement:
RSS-GenIssue48.4
This devicecomplieswithIndustryCanada’slicence-exemptRSSs. Operationis subject tothefollowing
twoconditions: (1)This devicemay
notcauseinterference;and (2)This devicemustacceptanyinterference,includinginterferencethat may
causeundesiredoperation of the
device.
Lepr sentappareil estconformeauxCNR d'IndustrieCanada applicables aux appareils radio exempts
delicence.L'exploitation estautoris e
auxdeux conditionssuivantes: (1)l'appareilnedoit pas produire de brouillage, et (2)l'utilisateur de
l'appareildoit acceptertout brouillage
radio lectriquesubi, mêmesile brouillageest susceptibled'encompromettre le fonctionnement.
Co-located
This deviceanditsantenna(s)must notbe co-locatedoroperating inconjunctionwithanyother antenna
or transmitter.
Cetappareiletsonantenne (s)nedoiventpas être situ soufonctionner en conjonction avecuneautre
antenne ou metteur.
RSS-GEN 8.3transmittersequippedwithdetachableantennas
This radiotransmitter(identifythe devicebycertificationnumber) has beenapproved byIndustryCanada
tooperatewiththe antenna types
Antenna gaininformation:Dipole ANTENNA:4dBi(2.4GHz),6dBi(5GHz)andFPCANTENNA2.5dBi
(2.4GHz),3dBi(5GHz)listedwiththe maximumpermissiblegainindicated. Antenna types notincluded in
thislist, havingagain greater thanthemaximumgainindicatedfor thattype,are strictlyprohibitedforuse
withthisdevice.
Cet émetteurradio(identifiezledispositifparnumérodecertification)a étéapprouvépar
IndustrieCanadapourfonctionneravec lestypes d antenne
Informationssurlegaind'antenne: ANTENNEDipolaire:4dBi (2,4GHz), 6dBi (5 GHz)et
ANTENNEFPC2,5dBi(2,4GHz),3dBi (5GHz)aveclegainmaximaladmissibleindiqué. Les
types d'antennes noninclusdanscetteliste, ayantun gainsupérieur augain maximumindiqué
pour ce type, sontstrictementinterdits pourcet appareil.
RSS-247 6.4(5) WLAN11a
(i)the deviceforoperation inthe band5150 5250MHzis onlyfor indoor usetoreducethepotentialfor
harmful interferencetoco-channelmobilesatellitesystems;
(iii) fordeviceswithdetachableantenna(s), themaximumantennagainpermittedfordevices in the band
5725-5850MHz shall be suchthattheequipment stillcomplies withthe e.i.r.p. limitsspecified for point-to-
point and non-point-to-pointoperation as appropriate;and
Usersshouldalsobeadvised that high-power radars are allocated as primaryusers(i.e.priorityusers)of
the bands5250-5350MHzand5650-5850MHzandthattheseradars couldcauseinterferenceand/or
damage toLE-LANdevices.
(i) l'appareil pour fonctionner danslabande5150-5250 MHzest r serv àuneutilisationenint rieur afin
der duire lesrisques d'interf rences
nuisibles àlaco-canalsystèmes mobiles par satellite;
(iii)pour les appareilsavecantenne(s)d tachable, le gaind'antennemaximalautoris pour les
appareils danslabande5725-5850MHzdoit
être tellequel' quipementsatisfait encorelapire limites sp cifi espour lepoint-à-point etnonpoint-à-
point,lecas ch ant;op ration et
Devraient galement être inform s lesutilisateurs que lesradars àhautepuissancesontd sign s
commeutilisateursprincipaux(c.-à-utilisateurs prioritaires)desbandes 5250-5350MHzet 5650-5850
MHzet que cesradars pourraient provoquer des interf rences et/ ou
endommager lesappareils LE-LAN.

(5/5)
ICRadiationExposure Statement:
mobile device
This equipmentcomplieswith ICRSS-102 radiation exposurelimits set forthfor an uncontrolled
environment. Thisequipment should be
installed and operated withminimum distance 20cmbetween the radiator & your body.
Modular Approval
OEM integrator is still responsible fortesting their end productfor any additional compliance
requirements required with this module installed
(for example, digital device emissions,PC peripheral requirements,etc.).
IMPORTANT NOTE: Inthe event thatthese conditionscannot be met (for example certain laptop
configurations or co-location with another
transmitter), then the IC authorization is no longer considered valid and the ICNo. cannot be used on the
final product.In these circumstances,
the OEM integrator willbe responsible for re-evaluating the end product (including the transmitter)and
obtaining a separate ICauthorization.
EndProductLabelingof Modular
This transmitter module is authorized onlyforusein device wherethe antenna maybe installedsuch that
20 cm maybe maintained between
the antenna and users.The final end productmustbe labeled in a visiblearea with the following:
“Contains transmitter module IC:IC:22364-QCA9377