TECO Tank TK 150 Instruction Manual

TK GUIDELINE
TK150 PROBE
REPLACEMENT
MODELS :
TK150
www.tecoonline.com | www.tecous.com

EQUIPMEMT
Tongs
www.tecoonline.com | www.tecous.com
black clamps
Screw-drivers
Thermostat Probe
(spare part)

STEP n.
1
Disconnect chiller from power supply.
Never touch internal part or dismount chiller when it is
connected to power supply to avoid potential electric shock.
www.tecoonline.com | www.tecous.com
WARNING! Parts replacements and reparation may be
carried out only by qualified persons. If this are not
performed properly, they can cause electric shock,
burns and fires

STEP n.
2
www.tecoonline.com | www.tecous.com
Remove the ring nut from the water IN/OUT pipe

STEP n.
3
Remove the chiller cover
www.tecoonline.com | www.tecous.com
Using the screwdriver, remove the two screws from the
back of the chiller and the two screws from the front

STEP n.
4
Disconnect the probe plug from the thermostat
Then, with the small screwdriver, disconnect the green connector from the old
probe wire and connect it to the new one.
www.tecoonline.com | www.tecous.com

STEP n.
5
Follow the probe wire. In order to remove the wire you have to cut the
clamps and replace them later.
Remove the insulation in the indicated area (without breaking it too much)
www.tecoonline.com | www.tecous.com

STEP n.
6
Remove the white probe insulation
Replace the probe taking care that the probe touches the pipe
www.tecoonline.com | www.tecous.com
White Insulation
Conductive Paste

STEP n.
7
-Replace the white insulation and the black insulated sheath
-Connect the probe plug to the thermostat and close the chiller
- Set “Ot” Parameter for probe Calibration
www.tecoonline.com | www.tecous.com

www.tecoonline.com | www.tecous.com
STEP n.
8