TECO TK Series Instruction Manual

TK GUIDELINE
THERMOSTAT
REPLACEMENT
MODELS :
TK500 – TK1000 – TK 2000
www.tecoonline.com | www.tecous.com

EQUIPMEMT
www.tecoonline.com | www.tecous.com
Screw-driver Thermostat
(spare part)

STEP n. 1
Remove the conveyor from
the top part of the chiller.
You can see the metal
black grid and the red fan
support.
www.tecoonline.com | www.tecous.com

STEP n. 2
Remove the air filter grid and air filter
from their position.
www.tecoonline.com | www.tecous.com

STEP n. 3
Using the screw-driver, remove the
4 INOX screws indicated in the
picture here below.
www.tecoonline.com | www.tecous.com

STEP n. 4
Remove the red fan support lifting it up from the
bottom edge.
Leave it on the metal cover, as you can see in the
picture.
www.tecoonline.com | www.tecous.com

STEP n. 5
Disconnect the main
green connector and
probe connector.
www.tecoonline.com | www.tecous.com

STEP n. 6
Remove the two white thermostat’s
supports. You can help you using a
screw driver.
www.tecoonline.com | www.tecous.com

STEP n. 7
Remove the
thermostat from its
placement and
replace it with a new
one. Insert the white
supports and connect
the two green
connectors.
www.tecoonline.com | www.tecous.com

STEP n.
Take the fan support
and fix it at the bottom
part of chiller.
Attention: the front
panel side must be
insert in the aluminum
profile!
www.tecoonline.com | www.tecous.com