TECO TK Series Instruction Manual

TK GUIDELINE
OVERHEATING
PROBE
REPLACEMENT
MODELS :
TK3000 – TK6000 – TK 9000
www.tecoonline.com | www.tecous.com

EQUIPMEMT
Tongs
www.tecoonline.com | www.tecous.com
7 black clamps
Screw-drivers
Probe
with red connector
(spare part)

STEP n. 1
Disconnect the chiller form power supply.
Using the screw-driver, remove the screws indicated in the
picture here below (n°16 screws).
www.tecoonline.com | www.tecous.com

STEP n. 2
www.tecoonline.com | www.tecous.com
Disconnect ground wire from the cover
Remove the cover

STEP n. 3
www.tecoonline.com | www.tecous.com
Disconnect the RED probe connector from
main board.
Cut the black clamps inside the chiller that
embrace the probe’s wire.

STEP n.
www.tecoonline.com | www.tecous.com
Proceed to cut all black clamps that
embrace the probe’s wire.
Extract the wire from circular passage.

STEP n. 5
www.tecoonline.com | www.tecous.com
-Cut the last black clamp
that embrace the
probe’s wire and copper
pipe near condenser
-Extract the probe and
replace it

STEP n. 6
www.tecoonline.com | www.tecous.com
-Insert probe cable in circular passage
-Connect new probe connector to main board
-Take new seven black plastic clamps and
pinch the probe’s cable with the other cables
as it was at the beginning.
-Place the chiller cover in its position and then
place the sixteen screws to close the chiller.
ATTENTION: remember to connect
ground wire to the cover before closing the
chiller.
CONNECT