Teknion Synapse Wood Guest Chair NSYN Operating and maintenance instructions

Synapse Wood Guest Chair (NSYN), Synapse Fully Upholstered Wood Guest
Chair (NSYF)
Part and Product Identification
Section:
Description: Page No:
Date:
Rev. No: 1
SYNAPSE INSALLATION GUIDES
MULTI-USE CHAIRS - SYNAPSE
Sept 2019 1 of 3
TSC_101
seating Installation Guides
A- Back x1
B- Front Legs with
Integrated Arms x1 Pair
D - Upholstered Seat x1
E - Uni-Frame x1
F - M8 x 35mm
Socket Cap Screw
(Q28-0385) x8
G - M6 x 25mm
Socket Cap Screw
(Q28-0386) x2
I - K50 x 25mm Screw
(Q28-0104) x9
C- Front Legs x1 Pair
Note: Use for Armless
Installation Only.
H - Cup Washer
(Q28-0374) x2
INTEGRATED ARMS
ARMLESS

FRONT
STEP 1: Align the Uni-Frame (E) to the Back Frame (A), ensuring the embossed lettering
indicating "FRONT" is positioned as shown. Insert the M8x35mm screws shown (F). Do not
tighten screws yet. Repeat for the other side.
STEP 2: Slide Integrated Arm (B) into cutaway slot of the back. Align leg with the Uni-Frame.
STEP 3: Fasten both legs to Uni-Frame using M8x35mm screws provided (F). Place the chair
upright on a flat surface. Tighten all 8 screws to a torque of 14Nm.
Section:
Description: Page No:
Date:
FASTEN BACK SLIDE INTEGRATED ARMS
FASTEN FRONT LEGS - INTEGRATED ARMS FASTEN FROT LEGS - ARMLESS OPTION
TSC_101
2 of 3
Sept 2019
SYNAPSE
MULTI-USE CHAIRS - SYNAPSE
seating Installation Guides
A
E
F
F
B
BC

Narrow End
Wide End
STEP 5: Place Seat at 45° and slide the corner of the seat towards the Arm. Orient the Seat by
turning and drop the seat onto the Uni-Frame.
STEP 4: Insert Cup Washer (H) into hole of each rear leg. Secure Back to Arms using
M6x25mm screws provided (G). Tighten both sides to a torque of 14Nm.
STEP 6: Fasten Seat Assembly onto Uni-Frame using K50x25mm screws provided (I).
Section:
Description: Page No:
Date:
SECURE BACK ASSEMBLY
INSTALL BACK ASSEMBLY
FASTEN SEAT ASSEMBLY
TSC_101
3 of 3
Sept 2019
SYNAPSE
MULTI-USE CHAIRS - SYNAPSE
seating Installation Guides
G
H
DI
NOTE: Use ONLY metric hex-head screwdrivers or bits to tighten socket cap screws.
DO NOT USE IMPERIAL SCREWDRIVERS OR BITS.
Tightening torque for the M8x35mm and M6x25mm socket cap screws: 14Nm