Teknion t-3 Owner's manual

SEAT HEIGHT ADJUSTMENT BACK TILT ADJUSTMENT
ARM HEIGHT ADJUSTMENT TENSION ADJUSTMENT
BACK HEIGHT ADJUSTMENT ARM WIDTH ADJUSTMENT
Lean back to determine if the
resistance is comfortable. If it is too
stiff, turn the knob counter-
clockwise to decrease tension. If it
does not provide enough
resistance, turn the knob clockwise
to increase tension.
o adjust the arm height, press the
small button on the outside of
either arm to raise or lower it to the
desired position. Release the
button to lock in place.
he tilt control paddle on the left
locks the chair in four positions.
o adjust the recline angle, push
the paddle down to unlock it.
Recline to the desired position and
lift the paddle up to lock in place.
o raise the chair, lift the paddle up
while lifting your weight from the
seat until you reach the desired level
and then release to lock in place. o
lower the chair, lift the paddle up
allowing your weight to push the
seat down to the desired level and
then release to lock in place.
he back height adjustment is
activated by the chair’s back.
o adjust the lumbar height, lean
forward and grasp both sides of the
lower portion of the outside back.
o raise, slide the back up. o
lower, slide the back all the way to
the top and then lower to desired
height. Release to lock in place. o adjust the arm width push the
lever down and slide the arm to the
desired position. Push the lever up
to lock the arm in place.
t-3 adjustment features & instructions

W rning
ipping or collapsing can result in serious injury. o prevent product failure and possible injury:
• his chair has been designed and tested for users weighing up to 250 lbs
• Frequently inspect the chair for visible cracks and damages, tighten all screws, bolts, adjustable knobs and parts
• Do not use the chair if damaged or unstable – immediately remove it from service
• his chair is equipped with casters intended for use on carpeted surfaces. Use of these casters on hard surfaces could result in unexpected rolling
and tipping. Casters designed for use on hard surfaces are available. If in doubt, see your dealer for appropriate selection
• Do not stand on or use the chair as a step ladder
• Failure to follow these warnings could result in serious injury
STOOL HEIGHT ADJUSTMENT STOOL FOOTRING HEIGHT ADJUSTMENT
o raise or lower the stool’s foot
ring, turn the foot ring’s knob
counter clockwise to release the foot
ring and adjust the ring until you
reach the desired level. urn the
knob clockwise to lock in place.
o raise the chair, lift the paddle up
while lifting your weight from the
seat until you reach the desired level
and then release to lock in place. o
lower the chair, lift the paddle up
allowing your weight to push the
seat down to the desired level and
then release to lock in place.
t-3 adjustment features & instructions