Tern Market Basket User manual

Tern Market Basket
ternbicycles.com T
ern Bicycles
Adjusting for Different Rack Tube Diameters
1. Unscrew one bracket and remove
spring rods.
2. Insert the rods into the appropriate
holes and reinsert the rods into the
bracket.
Ø 14-16 mm (upper hole):
Cargo Rack, Rapid Transit Rack, GSD
Rear Rack”
Ø 10-13 mm (lower hole):
Loader Rack, Trolley Rack, BioLogic
Post Rack, BioLogic Portage Rack 24,
BioLogic Portage Rack 20
3. Fasten the screws (2 Nm max).
1. Rest the red rubber inserts on the rail.
Specifications
Compatibility: All Tern & Biologic rear racks. Racks with tube diameter 10-16 mm and rack width 9-16 cm.
Maximum load capacity: 10 kg (22 lb)
Mounting the Basket
The bracket is set up for mounting a Tern Cargo™Rack or racks 11-13 cm wide with 14-16 mm diameter
tubes. To adjust the bottom bracket for different racks, see Adjusting for Different Rack Tube Diameters and
Adjusting for Different Rack Widths.
2. Position the levers anywhere along the
spring rod.
Ensure that no objects, such as strap
holder loop, prevent the levers from
closing completely.
3. Set the basket down, close the levers
and make sure the levers click in.
Make sure that the basket is securely
mounted before riding.
CLICK! CLICK!
Ø 14-16 mm Ø 10-13 mm

Adjusting for Different Rack Widths
LIMITED PRODUCT WARRANTY INFORMATION: This Product comes with a ONE (1) YEAR Limited Warranty from the date of retail
purchase by the original end-user. If a material or workmanship defect arises and a valid claim is received within the Warranty Period, this
Product will be replaced. Mobility Holdings cannot be held liable for damages to personal property due to misuse or improper care and
maintenance. This Product Warranty does not, under any circumstance, cover the replacement or cost of any third party product used with
or connected to the Product.
Tern, the Tern Werd (logotype), and the Tern Berd (device), and Market Basket, used alone or in combination are trade names, trade
devices or registered trademarks of Mobility Holdings, Ltd.
© 2017 Mobility Holdings, Ltd.
One of the spring rods can be fixed in
three different notch positions [A, B, C] in
the bracket.
A. Rapid Transit Rack
B. Loader Rack, Cargo Rack, GSD Rear
Rack, Freight Rack, BioLogic Portage 24,
and BioLogic Portage 20
C. Racks 9 – 11 cm in width
1. Slide the rubber rings on the spring rod
away from the brackets.
2. Push both ends of the spring rod away
from the notch and shift it to the desired
position.
3. Slide the rubber retainer rings towards
the brackets.
2. Remove spring rods and levers.
1. Loosen screws of brackets with
Cross-Head Screwdriver.
2. Place one bracket in the mounting
holes for the desired mounting
orientation.
Note the location of the red
rubber insert relative to the edge
of the basket. Incorrect orientation
will result in basket being
off-center.
3. Reinsert the rods into the bracket.
4. Tighten the screws (2 Nm max).
7. Slide the rubber retainer rings
against the brackets.
5. Install other bracket.
6. Tighten the screws (2 Nm max).
Changing Mounting Orientation
A/B/C
C
13-16 cm
B
11-13 cm
A
9-11 cm