three h Rescape User manual

• Product that is damaged by the end user due to misuse, accident, abuse,
negligence or shipping is not covered under Three H warranty.
• Use tools and hardware mentioned above to avoid any product faults.
• It is best to assemble our furniture with 2 or more persons.
• If you believe you are missing pieces, please contact [e-mail]
DISCLAIMERS!
INCLUDED HARDWARE
REQUIRED TOOLS
Hardware & tools required may vary depending on the Rescape™ Hutch specifics.
The following instructions do not specify the amount of hardware included.
Due to variations in design, a separate hardware list will be provided.
GETTING STARTED
To install the hutch, the Rescape Tiles must be installed first.
Allen Wrench
(Provided)
Bolts Threaded Rod

STEP 1
STEP 2
STEP 3
Position the Hutch
Mount the Hutch
Install the Tiles
Insert the Threaded Rods into half of the
pre-drilled holes on the Rescape Tiles.
These Rods are to assist with positioning
the Hutch, they will be removed after
Step 2.
HOLD THE HUTCH IN PLACE
Align the holes in the hutch back with the
Threaded Rods.
Fasten the Hutch using the bolts provided,
tighten securely using the Allen Wrench.
Carefully hang the tiles on the rails.
Starting with the tile slightly above the rails,
slide it downwards to clip the brackets onto
the rail (Figure A).
Lift upwards slightly to slide left or right for
tile alignment.
Repeat Steps 1 to 3 for all tiles.

Need Help?
[e-mail] | 1.800.767.5374