three h UPSIDE+ User manual

UPSIDE+

Ratchet No.2 Screwdriver
Dowels Set up Spacer 8 x 5/8 Screw Titus Connector VB ConnectorTitus Pin VB Pin M6x16 M6x30
5/32” Allen Wrench
(Provided)
• Product that is damaged by the end user due to misuse, accident, abuse,
negligence or shipping is not covered under Three H warranty.
• Use tools and hardware mentioned above to avoid any product faults.
• It is best to assemble our furniture with 2 or more persons.
• If you believe you are missing pieces, please contact [e-mail]
DISCLAIMERS!
INCLUDED HARDWARE
REQUIRED TOOLS
Hardware & tools required may vary depending on the UpSide™ specifics.
The following instructions do not specify the amount of hardware included.
Due to variations in design, a separate hardware list will be provided.
GETTING STARTED
Assemble on a soft surface to avoid scratching the worksurface.

STEP 1
STEP 2
STEP 3
Place the worksurface face down on a
soft, clean surface.
Install the Legs
Fasten the Legs
Place the height adjustable legs in
position. Align with the pre-drilled holes
for Step 3.
Using six M6x16mm bolts for each leg.

STEP 4
Fasten the Base Plates
Align the base plates with the pre-
drilled holes on the legs and fasten
using 4 M6x25mm bolts.
STEP 5
Leg Cover 1
Insert the Titus Pins on the bottom of the
worksurface where applicable. These are
used to position and fasten the first part
of the leg cover.
STEP 6
Mount the Legs
Align the Titus Pins with the pre-drilled
holes in the legs.

STEP 7
Fasten the Legs
Using a Ratchet, tighten the Titus
Connectors to the Titus Pins, these are
located inside the leg.
STEP 8
Modesty Installation
If applicable, mount the upper modesty
using the VB Pins and Connectors.
If you don’t have a modesty in your
configuration, skip this step.
STEP 9
Bottom Leg Cover
The bottom leg cover is shipped with
all the parts in place. Remove the
2 top “Spacers” from their dowels.
Remove the door + brackets and the
inner shelf.

STEP 10
Place Installation Jigs
Flip the desk up and slide a Jig
(provided) under each base plate.
Raise the desk to the highest
possible position.
STEP 11
Bottom Leg Installation
Slide in the Bottom Leg Cover from step
9 into position. The jigs should allow
enough room to get the Spacers back
onto the dowels.
STEP 12
Spacers, Door & Shelf
Re-install the Spacers, Door and
Shelf. Connect the inner shelf with
the VB Pins and Connectors.

STEP 13
Lower Modesty
If applicable, slide in the lower modesty onto the
VB Pins. Tighten the Connectors.
Skip this step if you don’t have a lower modesty.
STEP 14
Remove the Spacers
Slide out the spacers from the base
plates. If possible, do both at the same
time.
STEP 15
Control Install
Place the controller over the pre-
drilled holes and fasten using the
M6x20mm bolts.

Need Help?
[e-mail] | 1.800.767.5374
April 30, 2018
Revision No.1