three h WORKSHELF User manual

WORKSHELF™
INSTRUCTIONS
POWERSHELF

POWERSHELF
Information & Installation
Wood Dowel
Electric Drill
Threaded Connector
Pin
7/16” Wrench
M6x20 Bolt
5/32” Allen Wrench
(Provided)
Level No.2 Phillips
Screw Driver
No.8 Screw Titus Connector
• Product that is damaged by the end user due to misuse, accident, abuse,
negligence or shipping is not covered under Three H warranty.
• Use tools and hardware mentioned above to avoid any product faults.
• It is best to assemble our furniture with 2 or more persons.
• If you believe you are missing pieces, please contact [e-mail]
DISCLAIMERS!
INCLUDED HARDWARE
TOOLS REQUIRED
HARDWARE, TOOLS & COMPONENTS
Hardware & tools required may vary depending on the Powershelf™ specifics.
The following instructions do not specify the amount of hardware included due to the
amount of sizes available.

POWERSHELF
Information & Installation
Begin with the pre-assembled powerbeam on the floor.
The lip with holes should be facing upwards.
Position a leg upright and raise one side of the powerbeam.
Line up the holes on the leg to the holes on the powerbeam.
Using the provided Allen Wrench, insert 8 M6x20 bolts into their
designated holes.
Tighten securely. Repeat for the second leg. x16
STEP ONE STEP FIVE
STEP SIX
STEP SEVEN
STEP TWO
STEP THREE
STEP FOUR
Guide the table top down aligning the dowels and pins into the holes
on the legs. Be cautious of dropping it and damaging the laminate.
With the top face down on the floor, insert 3 dowels per corner and 1
threaded connector pin in the holes. Use a screwdriver on the
Threaded Connector Pins.
x12 x4
Tighten the Titus Connectors to lock the connector pin down.
Repeat on all Titus Connectors (x4).
Every hole underneath the shelf requires a No.8
Screw. It is best to use a power drill since there are
no pre-drilled holes.

Need Help?
[e-mail] | 1.800.767.5374
May 1, 2018
Revision No.1