three h UNITE CONFERENCE User manual

UNITE CONFERENCE
INSTRUCTIONS

INCLUDED HARDWARE
REQUIRED TOOLS
ATTENTION:
Failure to follow instructions may result in damage to the furniture.
Damage to furniture that occurs on site will not be replaced by
Three H Furniture.
NOTE: These guidelines are generic to the Unite Tables. Some
dierences in parts will be noticeable, this is a guide only.
UroScrew
Phillips Screwdriver Robertson Screwdriver
A B C D
Panhead Screw Fast Cap Screw VB Connector
PIECES
Top/ Surface Modesty PanelLeg/ Base
Power Drill

STEP ONE
Start with 1 Leg and 1 Modesty panel.
Align the pre-drilled holes with the appropriate hardware holes.
Tighten the pre-installed VB Connector onto the VB Pin, turn clockwise.
Use 2 UroScrews to fasten the 90° L Brackets into the pre-drilled holes.
Repeat Steps One and Two for the second Modesty Panel and attach
the second leg
Without the weight of the Top/ Surface, check to see the level status.
If the bases are not level, you can access the Levelers through the Base
Access Door. Turn the adjustable Levelers till it is level on all corners.
STEP TWO
STEP THREE
STEP FOUR
D
A

STEP FIVE
Place one Top piece in position on top of the Legs and Modesty.
The second Top piece has to slide into place. Slide it in carefully to
avoid damaging the tops.
Use Fast Cap Screws (C) in pre-drilled holes to attach the tops together.
6 Fast Cap Screws will already be pre-installed.
You will now have to work UNDERNEATH the table.
Rotate the Mending Plate into place over top of the pre-drilled holes.
Use the No.8 Panhead Screws (B) to fasten the Mending Plate.
Using UroScrews, attach all the 90° L Brackets from the Modesty to the
pre-drilled holes on the top.
Use the Base Access Door to attach those 90° L Brackets.
STEP SIX
STEP SEVEN
STEP EIGHT
C
B
A

Need Help?
[e-mail] | 1.800.767.5374
May 1, 2018
Revision No.1