three h Rescape Lite User manual

• Product that is damaged by the end user due to misuse, accident, abuse,
negligence or shipping is not covered under Three H warranty.
• Use tools and hardware mentioned above to avoid any product faults.
• It is best to assemble our furniture with 2 or more persons.
• If you believe you are missing pieces, please contact [e-mail]
DISCLAIMERS!
INCLUDED HARDWARE
REQUIRED TOOLS
Hardware & tools required may vary depending on the Rescape™ Lite specifics.
The following instructions do not specify the amount of hardware included.
Due to variations in design, a separate hardware list will be provided.
GETTING STARTED
Prior to assembly, mark your wall studs and ensure desking is level.
The FastCap Screws provided are for Wood Constructed studs only.
The installer will provide fasteners for any other stud material.
Electric Drill Level Ruler/ Tape
Measurer
Chalk Line
FastCap Screw

STEP 1
STEP 2
STEP 3
Measure
Install the Rails
Install the Tiles
A. Measure the total height of the tile
from the surface upwards and make
a mark.
B. From the top mark, measure down 3”
and snap a chalk line here.
C. From the bottom mark, measure up
3” and snap a chalk line.
Rescape Lite tiles include 3” inset
brackets that clip into the Rails.
Centered on the chalk line, begin fastening
the rail on the pre-marked stud locations.
Mount using FastCap Screws.
A min. of 4 Screws per rail is recommended.
Carefully hang the tiles on the rails.
Starting with the tile slightly above the rails,
slide it downwards to clip the brackets onto
the rail (Figure A).
Lift upwards slightly to slide left or right for
tile alignment.
Repeat Steps 1 to 3 for all tiles.
A
B
C
Figure A

Need Help?
[e-mail] | 1.800.767.5374