three h Hubub Table User manual

Hubub Tables
General Installation

Hubub 2
HUBUB
Lower the oval top plate down to the
bottom of the large main post.
Loosely thread in 4 M6x16mm screws
from the top plate to main post flange.
Tighten screws equally with supplied
allen wrench.
1
2
Allen Key
M6 x 16mm
Qty: 4

Hubub 3
HUBUB
Align the small front post to the middle
hole and thread in one M6x16mm
screw from the bottom of the plate.
Tighten screw with provided allen
wrench.
3
4
Allen Key
M6 x 16mm
Qty: 1
Attach the base to the posts using 3
M6x25mm screws.
With the Base and Posts lying on their
sides, thread the screws into the proper
holes.
Tighten each screw equally.
Allen Key
M6 x 25mm
Qty: 3

Hubub 4
HUBUB
Flip the table upright, the felt glides
should now be on the ground.
5
6
Place the worksurface on a clean, soft
surface.
Ensure the Main Post is closer to the
back of the worksurface.
Set post assembly in place and loosely
thread in all 6 M6x16mm screws.
Fasten screws equally until all tight.
Allen Key
M6 x 16mm
Qty: 6