Timago JMC-C 2052 User manual

1
INSTRUCTIONS FOR USE
Aluminium adjustable cane, foldable
Product code: JMC-C 2052
1. Characteristics
The cane consists of aluminium leg with wood-like handgrip, and of
soft anti-sliding rubber tip. Owing to push button height adjustment
and the possibility to fold the cane into three parts, the cane is very
comfortable in everyday use.
a. handgrip
b. wrist strap
c. height adjustment – locking pin
d. rubber tip
2. Application
The cane is ancillary equipment which is used to increase the area of
support in case of patients with reduced mobility. It is also
recommended to patients who need help and support while walking
and it can also be used as an aid in keeping balance after the injuries of
lower limbs or trunk.
Contraindications: coordination and balance disorders, advanced
rheumatic changes, injuries and dysfunctions of upper limbs which may
hinder the user to support on the cane.
3. Adjustment
To adjust the cane, press the metal pin and select appropriate position
of the inner tube. Lock the position of the tubes relative to each other
with the use of metal pin. The cane is adjustable in 2.5 cm increments
within the range of 78-88 cm.

2
•To set the proper length of the cane, stand upright and bent
upper limb in elbow joint at the angle of 20°.
•The cane should be adjusted individually to the user so that the
handgrip is at hip joint level.
•Before use, ensure that the cane is stable and the locking pin fully
protrudes through adjustment hole of the cane.
NOTE! In case of doubts concerning the technique of moving with the
use of cane, consult a person who has appropriate knowledge or
qualifications.
4. Technical data
Type: foldable
Colours: brown, black
Height adjustment:78-88 cm
Maximum capacity: 90 kg
Cane weight:0.38 kg
5. Notes
Timago International Group does not bear responsibility of improper
use of the product, failure to comply safety regulations and misuse.
6. Cleaning and maintenance
•Clean the cane using only water and mild detergents, dry
thoroughly.
•Do not use: strong detergents, abrasive agents, bleach, petrol nor
solvents (it may cause frame damage, visible defects, and in
consequence – loss of warranty rights).
•It is recommended to check rubber tip regularly. Replace worn tip
immediately.
7. Storage and transport conditions
Device should not be exposed to direct sunlight, water or moisture.

3
8. Warranty information
All products distributed by our company are covered by a warranty, the
terms of which are described in the warranty card available on our
website. Please contact the retailer from whom you purchased the
product. Please, keep in mind that for warranty purposes, the proof of
purchase (receipt or invoice) should be retained
9. Labels
Reference
number
Manufacturer
LOT number Manufacture date
Serial number Medical device
Note
Please read the
instruction
The manufacturer checked for compliance with
essential medical devices requirements.
Our complete line of products is available from our distributors.
Learn more at: www.timago.com. Thank you for choosing Timago!
Timago International Group
Spółka z o.o. i Spółka – Spółka komandytowa
ul. Karpacka 24/12
43-316 Bielsko-Biała, Polska
T.: [phone]
F.: [phone]
E.: [e-mail]
Rev. II, date 20.05.2021