Timago JMC-C 2680SL User manual

1
INSTRUCTIONS FOR USE
Aluminium tripod cane with long legs
Product code: JMC-C 2680SL
1. Characteristics
The tripod cane consists of aluminium-steel frame, height
adjustable ergonomic and chromed handle with soft
foamed handgrip, and of powder coated base with three
legs.
a. handgrip
b. height adjustment – locking pin
c. rubber tips
2. Application
The tripod cane is ancillary equipment designed for patients with
reduced mobility who need help and stable support while walking. The
tripod is also recommended to elderly people as an aid in keeping
balance. The design with three legs provides better stability than
regular canes.
Contraindications: coordination and balance disorders, advanced
rheumatic changes, injuries and dysfunctions of the upper limbs which
may hinder the user to support on the tripod cane.
3. Adjustment
To adjust the tripod cane, press the metal pin and select appropriate
position of the inner tube. Lock the position of the tubes relative to
each other with the use of metal pin. The tripod is adjustable in 2.5 cm
increments within the range of 77-98 cm.
•To set the proper length of the tripod, stand upright and bent
upper limb in the elbow joint at the angle of 30°.
•The tripod should be adjusted individually to the user so that the
handgrip is at the hip joint level.

2
•Before use, ensure that the tripod cane is stable and the locking
pin fully protrudes through adjustment hole of the tripod cane.
NOTE! In case of doubts concerning the technique of moving with the
use of tripod, consult a person who has appropriate knowledge or
qualifications.
4. Technical data
TYPE: adjustable
Leg colour: silver
Base colour: black
Handgrip: black, foamed
Height adjustment: 77-98 cm
Maximum capacity: 100 kg
Tripod weight: 0.6 kg
Base dimensions: 24.5 cm x 29.5 cm
5. Notes
Timago International Group does not bear responsibility of improper
use of the tripod, failure to comply safety regulations and misuse.
6. Maintenance and cleaning
•
Clean the tripod cane using only water and mild detergents.
•
Do not use: strong detergents, abrasive agents, bleach, petrol nor
solvents (it may cause frame damage, visible defects, and in
consequence - loss of warranty rights).
•
It is recommended to check rubber tips regularly. Replace worn
tips immediately.
7. Storage and transport conditions
Device should not be exposed to direct sunlight, water or moisture.
8. Warranty information
All products distributed by our company are covered by a warranty, the
terms of which are described in the warranty card available on our
website. Please contact the retailer from whom you purchased the

3
product. Please, keep in mind that for warranty purposes, the proof of
purchase (receipt or invoice) should be retained
9. Labels
Reference
number
Manufacturer
LOT number Manufacture date
Serial number Medical device
Note
Please read the
instruction
The manufacturer checked for compliance with
essential medical devices requirements.
Our complete line of products is available from our distributors.
Learn more at: www.timago.com. Thank you for choosing Timago!
Timago International Group
Spółka z o.o. i Spółka – Spółka komandytowa
ul. Karpacka 24/12
43-316 Bielsko-Biała, Polska
T.: [phone]
F.: [phone]
E.: [e-mail]
Rev. II, date 20.05.2021