Toro 133-2861 User manual

FormNo.3405-190RevA
WireHarnessUpdateKit
2013andAfterMultiPro®5800TurfSprayerUltraSonicBoom™
FinishingKit
ModelNo.133-2861
InstallationInstructions
WARNING
CALIFORNIA
Proposition65Warning
ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato
causecancer,birthdefects,orreproductiveharm.
Installation
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescriptionQty.Use
1Nopartsrequired–Installthekit.
1
InstallingtheKit
NoPartsRequired
Procedure
1.Parkthemachineonalevelsurface,settheparking
brake,shutofftheengine,andremovethekeyfrom
theignitionswitch.
2.Disconnectthenegative(-)batterycablefromthe
battery.
3.Removethe5boltsfromtherightpanelonthecontrol
console,thenremovethepanel(Figure1).
Figure1
1.Leftactuatorswitch3.Rightpanel
2.Rightactuatorswitch4.Bolt
©2016—TheToro®Company
8111LyndaleAvenueSouth
Bloomington,MN55420
Registeratwww.T oro.com.OriginalInstructions(EN)
PrintedintheUSA
AllRightsReserved*3405-190*A

4.Removethecabletieclosesttothewireharness
connectorstotheleftandrightactuatorswitches.
5.Disconnecttheconnectorsfrombothactuatorswitches
(Figure1).
6.Cutthe3wireswithin2.5cm(1inch)oftheconnector
fortheleftactuatorswitchandstrip1.0to1.3cm(3/8
to1/2inch)ofthewire(Figure2).
Figure2
1.2.5cm(1inch)
7.Installthewiresintotheheat-shrinksplicesofthekit
wireharness,matchingthecolorsofthewires(Figure
3).
Figure3
1.Wire2.Heat-shrinksplice
8.Crimpall3wires.
9.Repeatsteps6through8fortherightactuatorswitch.
10.Heattheinsulationonbothendsoftheheat-shrink
splicesuntilthewiresaresealed.
11.Useacabletietosecuretheconnectorfortheindicator
lighttothewireharness.
12.Slidetheconvolutedtubingonthewireharnessto8.9
cm(3-1/2inches)fromtheconnectorsandsecureitin
placeusing1or2cableties.
13.Connecttheconnectorstotheirrespectiveactuator
switches(Figure1).
14.Installtherightpanelonthecontrolconsole(Figure1).
15.Connectthenegative(-)batterycabletothebattery.
2