Transition Networks MIL-L100i User manual

MIL-L100i
Single-Port Power over Ethernet Mid-span Injector
User Guide
Ensures uninterrupted network operation
Intelligent endpoint detection process
Easy, cost-effective installation
Provides a secure central power location
Contents
1. Introduction ...............................................................................................................................................1
Regulatory Approvals ...............................................................................................................................3
Features....................................................................................................................................................4
Package Contents ....................................................................................................................................4
2. Hardware Description................................................................................................................................5
3. Installation.................................................................................................................................................6
4. Technical Specifications............................................................................................................................7
Contact Us................................................................................................................................................8
Compliance Information............................................................................................................................8
Record of Revisions..................................................................................................................................9
1. Introduction
Thank you for purchasing MILAN by Transition's MIL-L100i Single Port Power over Ethernet (PoE)
Injector. The MIL-L100i provides data and AC power through the Ethernet cable to PoE enabled devices,
such as AP, a network camera, or other equipment supporting IEEE 802.3af. The injector is typically
installed near the Ethernet switch.
MILAN by Transition's new EmPowered Ethernet™Series Power over Ethernet solutions deliver unified
supply of data, voice, and video as well as electrical power through a single source by sending power
over standard Category 5 and above twisted pair cables. Power over Ethernet simplifies installation and
eliminates the need to run separate power cords and LAN cables to each Access Point or port locations.
Our new PoE products provide organizations with affordable, easy-to-use solutions that enable them to
migrate their network infrastructure to support a growing number of advanced cost-saving, performance
enhancing applications, such as streamlining wireless, VOIP, Network IP camera deployments, and
centralized power backup solutions. Whether on a factory floor or in an enterprise facility, running power
to hard-to-reach locations with our Power over Ethernet solution significantly reduces cabling and outlet
requirements while providing the lowest total cost of ownership.
90000430 Rev. C http://www.transition.com/ Page 1 of 9

Transition Networks MIL-L100iUserGuide
The figure below shows a sample of a Power over Ethernet Injector application.
Figure 1-1. Power over Ethernet Injection Application
90000430 Rev. C http://www.transition.com/ Page 2 of 9

Transition Networks MIL-L100iUserGuide
Regulatory Approvals
- FCC Class A
- UL 1950
- CSA C22.2 No. 950
- EN60950
- CE
- EN55022 Class A
- EN55024
Canadian EMI Notice
This Class A digital apparatus meets all the requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numerique de la classe A respecte toutes les exigences du Reglement sur le materiel
brouilleur du Canada.
European Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage
Directive (73/23/EEC) issued by the Commission of the European Community Compliance with these
directives imply conformity to the following European Norms:
EN55022 (CISPR 22) - Radio Frequency Interference
EN61000-X - Electromagnetic Immunity
EN60950 (IEC950) - Product Safety
Five-Year Limited Warranty
Transition Networks warrants to the original consumer or purchaser that each of its products, and all
components thereof, will be free from defects in material and/or workmanship for a period of five years
from the original factory shipment date. Any warranty hereunder is extended to the original consumer or
purchaser and is not assignable.
Transition Networks makes no express or implied warranties including, but not limited to, any implied
warranty of merchantability or fitness for a particular purpose, except as expressly set forth in this
warranty. In no event shall Transition Networks be liable for incidental or consequential damages, costs,
or expenses arising out of or in connection with the performance of the product delivered hereunder.
Transition Networks will in no case cover damages arising out of the product being used in a negligent
fashion or manner.
Trademarks
The MiLAN logo and MiLAN Technology trademarks are registered trademarks of MiLAN Technology in
the United States and/or other countries.
90000430 Rev. C http://www.transition.com/ Page 3 of 9

Transition Networks MIL-L100iUserGuide
Features
Power Over Ethernet Injector
IEEE802.3af Compliance
Remote power feeding
Short circuit protection
Mix Ethernet and power into RJ-45 port
Deliver power up to 100 meters
Light weight and compact size
Plug-and-Play
Package Contents
Unpack the contents of the package and verify them against the checklist below.
One MIL-L100i Power over Ethernet Injector
Power Cord
User Manual
Post Card
If any item is missing or damaged, please contact your local dealer for service.
90000430 Rev. C http://www.transition.com/ Page 4 of 9

Transition Networks MIL-L100iUserGuide
2. Hardware Description
The Power over Ethernet Injector has three connection ports and one LED indicator.
Data In port: RJ-45 Ethernet interface port for data transmitting from the switch to the PoE
Injector.
Figure 2-1. Data In and PowerIn ports
Power In port: The Power In port is for supplying the power to the Injector.
Data Out port: RJ-45 Ethernet port with a fixed RJ-45 cable to connect to a PoE Splitter, PD, or
PoE Hub.
Figure 2-2. Data Out port
90000430 Rev. C http://www.transition.com/ Page 5 of 9

Transition Networks MIL-L100iUserGuide
3. Installation
To install the Power over Ethernet Injector, please follow these steps.
1. Use RJ-45 cable from the Data in port on the Power over Ethernet Injector to the Ethernet Switch.
2. Use RJ-45 cable from the Data out port on the Power over Ethernet Injector to the network
camera, PD (Such as Router, Access Point, etc.) or PoE Hub.
3. Plug in the power cord of the Power over Ethernet Injector to the appropriate power source.
4. Before starting, make sure all connections are correct.
90000430 Rev. C http://www.transition.com/ Page 6 of 9

Transition Networks MIL-L100iUserGuide
4. Technical Specifications
The following table provides the Power over Ethernet Injector technical specifications.
Standard IEEE802.3/3u 10BASE-T/100BASE-TX
IEEE802.3af Power over Ethernet
Connector DC out: Power pin: 4,5(V+), 7,8(V-)
Network Cable 10BASE-T: 2-pair UTP/STP Cat.3, 4,5 cable
EIA/TIA-568 100-ohm (100m)
100BASE-TX: 2-pair UTP/STP Cat.5 cable
EIA/TIA-568 100-ohm (100m)
LED Green LED indicates PoE Power is now being injected
Power Input 100~240V, 50~60Hz, 0.25A
Output Power 48VDC, 0.3A
Operating environment 0 º ~ 40 ºC
Operating Humidity 90% Humidity (non-condensing)
Storage Temperature 0 º ~ 70 º C
Dimensions 117mm x 60mm x 35mm (L x W x H)
EMI & Safety FCC Class B, CE, UL, cUL, CE/EN60950
90000430 Rev. C http://www.transition.com/ Page 7 of 9

Transition Networks MIL-L100iUserGuide
Contact Us
Technical support
Technical support is available 24-hours a day
US and Canada: 1-800-260-1312
International: 00-1-952-941-7600
Transition now
Chat live via the Web with Transition Networks Technical Support.
Log onto www.transition.com and click the Transition Now link.
Web-based seminars
Transition Networks provides seminars via live web-based training.
Log onto www.transition.com and click the Learning Center link.
E-Mail Ask a question anytime by sending an e-mail to our technical support staff.
[email protected]
Address
Transition Networks
10900 Red Circle Drive
Minnetonka, MN 55343, U.S.A.
telephone: [phone]
toll free: 800-526-9267
fax: [phone]
Compliance Information
FCC regulations
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which
case the user will be required to correct the interference at the user's own expense.
Canadian regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set
out on the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la Class A prescrites dans le Règlement sur le brouillage
radioélectrique édicté par le ministère des Communications du Canada.
90000430 Rev. C http://www.transition.com/ Page 8 of 9

Transition Networks MIL-L100iUserGuide
90000430 Rev. C http://www.transition.com/
European regulations
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses
Gerätes Rundfunkstörungen auftreten. In diesem Fäll is der Benutzer für Gegenmaßnahmen
verantwortlich.
Attention !
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l'utilsateur de prende les measures spécifiques
appropriées.
In accordance with European Union Directive 2002/96/EC of the European Parliament and
of the Council of 27 January 2003, Transition Networks will accept post usage returns of
this product for proper disposal. The contact information for this activity can be found in the
'Contact Us' portion of this document.
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC
TELEPHONE NETWORK. Failure to observe this caution could result in damage to the
public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EGMitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
Record of Revisions
Rev Date Notes
A 10/01/05 Initial release.
B 02/02/09 Manual update.
C 09/10/12 Warranty period update and format changes.
All trademarks and registered trademarks are the property of their respective owners.
Copyright restrictions
© 2003-2012 Transition Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means - graphic, electronic
or mechanical - without written permission from Transition Networks.
Page 9 of 9