Travis Industries Fireplace Xtrordinair 864 Deluxe User manual

864 Deluxe Birch Log Set
sku# 94500720
Page 1 of 7 17602062 — 4/2/19 © Travis Industries, Inc.
Compatibility
864TRV (31K) – Standard or CleanFace
864TV (40K) – Standard or CleanFace
864TRV Fireplace (replacement set)
Packing List
10 Piece Log Set
Installation Warnings
NOTE: Consult the installation manual for order of installation. If using propane (LP), convert the appliance
before installing the log set. If using firebacks, install them prior to installing the log set.
The logs are fragile, especially after being exposed to heat.
Make sure the gas control valve is OFF and the heater is cool prior to conducting service.
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
The burner must be correctly positioned before installing the log set. Make sure the burner is fully seated
and the pilot is properly aligned. See owner’s manual for details on burner removal.
Log Set Overview – Birch
When installed, the ten (10) logs should appear as shown below.
Center Twig
250-04858 Front Ember Chunk
250-04852
Right Log
250-04854
Back Log
250-04850
Center Left Twig
250-04856
Left Log
250-04853
Center Log
250-04859
Right Twig
250-04855
Front Left Log
250-04851
Left Twig
250-04857

864 Deluxe Birch Log Set
sku# 94500720
Page 2 of 7 17602062 — 4/2/19 © Travis Industries, Inc.
Installation
Back Log
The back log has two pockets that insert over two tabs on the back burner (see photos below).
Place the log in place and push it back. The log straddles the burner and does not cover any
burner holes.
Right Log
The right log has a channel on the bottom that fits over the grate. Place the log in place and
slide it to the rear.

864 Deluxe Birch Log Set
sku# 94500720
Page 3 of 7 17602062 — 4/2/19 © Travis Industries, Inc.
Front Left Log
The front left log has a channel that fits over the grate. When in place the knob on the front of
the log fits over the grate as well.
Left Log
The left log has a channel on the bottom. Place this channel over the grate. When in place,
make sure the log is positioned so it does not block any burner holes.

864 Deluxe Birch Log Set
sku# 94500720
Page 4 of 7 17602062 — 4/2/19 © Travis Industries, Inc.
Center Twig
The center twig is shown below. It has a pin on the bottom side. When in place, the fork on
the front straddles the grate and the pin rests on the rear burner (make sure it is not over any
burner holes).
Front Ember Chunk
The front ember chunk has a groove on the bottom that fits over the grate. Place it as shown
below.
Pin rests on burner
Notch
straddles
grate

864 Deluxe Birch Log Set
sku# 94500720
Page 5 of 7 17602062 — 4/2/19 © Travis Industries, Inc.
Left Twig
The left twig has a hole on the bottom that fits over the pin on the front left log. Place the twig
as shown below. The front left log has a groove that will point the twig upwards and to the
right.
Center Left Twig
The left center twig is flat on the bottom and has a fork at one end. Place the twig as shown
below. Note how the twig rests in the groove in the front left log and the right end hangs over
the burner but does not rest on it.

864 Deluxe Birch Log Set
sku# 94500720
Page 6 of 7 17602062 — 4/2/19 © Travis Industries, Inc.
Center Log
The center log has a hole on the back and a fork on the front. Position the log so this fits over
the pin on the back log. Make sure the fork on the front of the log fits over the grate as shown
below.
Right Twig
The right twig has a hole on the bottom that fits over the pin on the right log. Position the twig
so it rests on the back log as shown below.
Fits over pin
on rear log
Fits over grate as
shown to right

864 Deluxe Birch Log Set
sku# 94500720
Page 7 of 7 17602062 — 4/2/19 © Travis Industries, Inc.
Ember Installation
NOTE: The embers are included with the fireplace. Consult the installation manual for details
on installing the embers. If using the ember bed light, the embers are installed with the
ember bed light glass.
Embers are provided to further enhance the firebox. Place the embers on the firebox floor and
on the burner. Do not place embers over any of the burner holes or air channels.
Rock Wool Placement
NOTE: The rock wool is included with the fireplace. Consult the installation manual for details
on installing the rock wool.
The included rock wool is placed on top of the burner to enhance the glow from the burner.
The rock wool works best when it is applied in a very thin, porous layer. The best method
for applying the rock wool is to brush it on to the burner. Compress a clump of rock wool
between your thumb and forefinger. Use a stiff brush to apply a thin layer of rock wool fibers
onto the burner. Do not use the entire bag of rock wool. Use only a small amount and save the
remainder. Over-use of rock wool will diminish the glow and may cause sooting or other
adverse conditions.