TUBESCA-COMABI PROFORT X'TEND User manual

61029_321_ind_00 of 01/2014 http://www.tubesca-comabi.com/ PAGE 1/2
PROFORT X’TEND operating instructions, ref: 02272/750
Product compliant with standard NF P 93-353 of December 2009
3 --> 4 --> 5
0.7--> 0.93 --> 1.16 1.28-->1.47-->1.65 0.78-->1.57-->1.57 20.5 1.36x0.49x0.76
150Kg
Pf
Ht
1
2
3
4
Lg
LxH x Winm
H
L1 (m)
L2 (m)
Kg
Kg
Product folded
1. Product description
This individual mobile platform for individual use is designed for finishing and equipment fitting work The platform can be used by just one
operator working on the ground.
It is fitted with two non-swivel rollers used for positioning it.
It is equipped with two independent adjustable stabilizers for use in 4 and 5 step versions. The stabilizers hold the unit perfectly securely
under the normal operating conditions recommended by the standard.
Put the guardrail in place
by pivoting it
LOCK THE CAM
The stabilizer is put in place by unlocking the cam. It is in place once it
makes contact with the floor. The cam must then be locked in position
before the unit can be used.
2. Use
2.1. Assembly
Undo the velcro fastener and unfold the platform by lowering it
THE PIN MUST
BE ‘OUT’
Take hold of the two guardrail tubes
THE LOCK MUST
BE CLOSED
Adjust the size of
the unit step by
step.
Unlock the hook with your right hand. Take hold of the platform with your left hand and raise so that the hook is lowered
below the bottom step.

PROFORT X’TEND operating instructions, ref: 02272/750
61029_321_ind_00 of 01/2014 http://www.tubesca-comabi.com/ PAGE 2/2
2.2.Access
2.3. Moving 2.4. Work positions
Moving when unfolded
2.4.Closing
To fold up the telescopic section, carry out the assembling operations in the reverse order
2.6.Tool-holder, option ref.: 02272/526
3. Recommendations for use:
+ Do not use the platform without its guardrails, nor behind any door that has not been locked.
+ The platform must only be used on horizontal, non-slip surfaces.
+ All the platform’s feet must be in contact with the floor or ground.
+ On soft ground, a support plate must be placed under every foot.
+ Make sure that the work area is away from any bare conductor under power.
+ The platform must not be thrown or handled brutally when in use.
+ Always face the platform when climbing or coming down from it.
+ Make sure that you are wearing shoes that give you a firm footing.
+ Do not climb up the ladder if you suffer from vertigo or are tired.
+ Do not use the ladder without putting the stabilizers in place
4. Maintenance:
+ Systematically check that the platform is in a good general condition before use (condition of parts and their geometry. Should parts
need to be replaced only use TUBESCA-COMABI components, see constructor after-sales service instructions)
+ After use on a site, wipe the ladder with a clean cloth.
+ The ladder must be regularly checked and results of the check must be recorded.
2possible positions Unscrew the nuts Put the tool-holder in place
Put the hooks in place and
tighten the knobs
Tighten the
knobs firmly
Moving when folded
HOLDER.
Open the gate to reach the work-floor. Once you are in position, the gate must be closed for working under correct conditions.
CLIP THE GATE INTO ITS