Turner Designs FluoroSense User manual

www.turnerdesigns.com
998-2851
B
Page 1
Quick Start Guide
Battery Installation
Calibration
•To calibrate, press and hold Read
button while unit is off.
•While holding Read button, press and
hold Power button until 100 appears
on screen. Release both buttons.
•Place the sensor in the FluoroSense
Standard Solution appropriate for
your optics. Shake gently to make
sure bubbles are purged from the cap
and press Read button.
•The display will flash “td” several
times and then the unit will
automatically turn off. At this point
the FluoroSense is calibrated.
Note: Unit ships calibrated. Only
re-calibrate if unit does not read
100 3% for the Standard Solution
appropriate for your FluoroSense.
READ
100

www.turnerdesigns.com
998-2851
B
Page 2
Quick Start Guide
Operation
•Press the Power button.
•Place the sensor in the sample
with the cap fully submerged.
•Shake gently to make sure
bubbles are purged from the cap.
•Press the Read button.
•Maximum reading displayed is 199,
concentrations greater than the
maximum reading will be displayed
as 199.
READ
40
•Rinsing with fresh water and drying
the instrument thoroughly with a
non-abrasive cloth after use is
recommended.
•Visual inspection of the optical face
for fouling should be done on a regular
basis..
•To inspect the optical face remove the
cap:
•If there is any noticeable fouling, use a
soft bristle brush or non-abrasive cloth
and soapy water to clean the optical
window. Rinse thoroughly.
Note: The FluoroSense should NOT
come in contact with any organic
solvents or strong acids and bases.
Rotate the cap
until the seam
is aligned with
opening. Then
remove the cap.
Reverse steps
to install the
cap.
Maintenance and Cleaning