Tylo Steam Outlet Commercial User manual

STEAM OUTLET
Commercial
2017-05-01
2900 0724
INSTALLATION GUIDE

2
1.3.
8.
2.
5.4.
4.
7.
6.
PRIOR TO INSTALLATION
Parts
Check that the following parts are included in the packaging:
Figure 1: Steam Outlet Commercial parts
1. Steam Outlet Commercial Box x 1
2. Left Side Cover x 1
3. Right Side Cover x 1
4. Washer x 2
5. Screw 8 mm x 2
6. Membrane x 3
7. Screw 25 mm x 2
8. 15 mm threaded drain pipe
Contact your dealer if anything is missing.
Installation tools
The following tools and materials are needed for installation and
connection:
• knife
• screwdrivers.
Installation planning
Before starting to install your sauna heater:
• Install the Steam Outlet before installing the sauna heater on
the wall.
• Plan how the steam pipe should be installed (See the in-
stallation guide for the Steam Generator how to do a proper
steam pipe installation)
• Which side the steam pipe should be installed on the Steam
outlet Commercial?
• Plan for the drainage
• Use as large pipe as possible (1 “) for the steam to keep
noise down and as little sharp bend close to the Steam Outlet
possible.
7.5.

3
Align vertical
x2
Figure 2: Step One
Mount the Steam Outlet Commercial (nr 1) from behind on the
Sense Commercial sauna heater between the top brackets when
the heater is not mounted on the wall, rest the lip on the
sauna grill.
Figure 4: Step Three
Cut a hole in one rubber membrane (nr 6) for the dimension of
your steam pipe you and mount it on the side where the steam
pipe is. Plug the other side with a membrane.
Figure 5: Step Four
Make the Installation of the Sense Commercial sauna heater, see
installation guide, 2900 5300
Figure 3: Step Two
Aligned it vertical and xate it with the screws (nr 5) and washers
(nr 4).
x2
SENSE COMMERCIAL 2017-12-15
2900 5300
SVENSKA
INSTALLATIONSANVISNING
ENGLISH
INSTALLATION GUIDE
DEUTSCH
INSTALLATIONSANLEITUNG
FRANÇAIS
NOTICE D’INSTALLATION
РУССКИЙ
ИНСТРУКЦИИ ПО УСТАНОВКЕ
POLSKI
INSTRUKCJA INSTALACJI
NEDERLANDS
INSTALLATIEHANDLEIDING
A

4
30 mm
Steam In
642 mm
270 mm
Drainage
Figure 7: Step Six
• Lock it with the screw (nr 7)
• Repeat on the other side.
Figure 8: Step Seven
• Pipe enter 642 mm from the oor
• Insert the steam pipe, align it horizontal with 30 mm pipe
inside.
• Connect the to the drain pipe to a drainage (15 mm connec-
tion). Let the pipe go down into the water to minimize steam
leakage.
• Plug the hole in the other side cover with the last rubber
membrane.
Figure 6: Step Five
Mounting the side covers.
A. Angle the cover inside the bracket screws and push it inwards
B. Twist it in
C. Push it in place, upwards
A.
B.
C.
A.