U-Line H-2557 User manual

PAGE 1 OF 2 0115 IH-2557
πH-2557
Foaming Soap
puSH DiSpenSer
1-800-295-5510
uline.com
TAPE INSTALLATION
Use only on smooth, dry surfaces
1. Install the dispenser at least 10"
(25.4 cm) above counter top.
(See Figure 1)
2. Clean installation surface
with supplied prep pad. Allow
surface to dry for 60 seconds.
3. Peel paper off of installation
tape and press dispenser firmly
into position. (See Figure 2)
4. Open dispenser by inserting key
into key access holes and push
up until front cover opens. (See
Figure 3)
5. Press firmly on back plate for 30
seconds. For maximum adhesion,
do not load refill for 24 hours.
(See Figure 4)
FASTENER INSTALLATION
Use on rough or smooth surfaces
1. Open dispenser by pushing on
cover latch until it releases. (See
Figure 1)
2. Using back plate as template,
mark and drill center holes using
1/4" (6.3 mm) spiral masonry drill
or 1/4" wood drill.
3. Install #10 x 1" (2.54 cm)
fasteners into 4 installation holes
in back plate and through
installation tape. (See Figure 2)
4. Peel paper off installation tape,
line up fasteners with anchors,
and press dispenser firmly into
position. (See Figure 3)
5. Tighten fasteners securely. Be
careful not to over-tighten. (See
Figure 4)
INSTALLATION
Figure 1
Figure 3
Figure 4
Figure 2
Figure 3
Figure 1
10 in.
Figure 2
Figure 4

PAGE 2 OF 2 0115 IH-2557
STANDARD KEY
1. Insert standard key into key
access hole underneath the
cabinet. (See Figure 1)
2. Push up until front cover opens.
(See Figure 2)
LOCK BYPASS OPTION
This option is permanently affixed once it has
been inserted into the dispenser.
1. Snap insert into key access hole.
Make sure it snaps in place.
(See Figure 1)
2. After assembled, push up until
front cover opens. (See Figure 2)
LOCK OPTIONS
Figure 1
Figure 2
Figure 2
Figure 1
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com