U-Line H-2999 User manual

0115 IH-2999PAGE 1 OF 2
πH-2999
6'WOODEN
PICNIC TABLE
1-800-295-5510
uline.com
Prior to assembling your table, apply two coats of water
repellent to the table components.
1. Place the pre-drilled seat cross-member on top of
the pre-drilled table legs. Position the legs so the
holes are aligned and the tops of the legs are level
and straight. (See Figure 1)
NOTE: There are predrilled holes on one end
of the table legs, these should be on the top of
the assembled legs.
2. Loosely attach with the 3½" carriage bolts through
the pre-drilled holes using the washers and nuts.
Repeat for the second leg.
PARTS
Preassembled Table Top x 1
72" Seat Plank x 4
59" Pre-Drilled Seat Cross-Member x 2
23.5" Diagonal Brace x 2 10" Seat Block x 2
3½" Carriage bolt x 8 2½" Wood Screw x 36
Washer x 8 Nut x 830" Pre-Drilled Table Leg x 4
TOOLS NEEDED
Drill Tape Measure 7/16" Socket Wrench 1/8" Drill Bit Level
Figure 1
ASSEMBLY

0115 IH-2999PAGE 2 OF 2
ASSEMBLY
3. Make sure legs are level and tighten all 3½"
carriage bolts using a 7/16" socket wrench.
4. Place the preassembled table top upside down.
Position the legs on the inside mount of the support
bar. Make sure the legs are equal distance from
either table edge and the cross-member is facing
out. (See Figure 2)
5. Loosely attach using four 2½" wood screws through
the pre-drilled holes. Repeat steps to attach the
other leg.
6. Make sure the legs are perpendicular to the table
top to ensure table top is level. Pre-drill and attach
diagonal braces using four 2½" wood screws to the
cross-member and preassembled table top.
(See Figure 3)
7. Flip the table so it is right side up.
8. Attach a seat block to the center of two seat planks.
Attach using two 2½" wood screws on the block.
Repeat for the second seat plank. (See Figure 4)
9. Place the outside edge of the seat bench flush with
the ends of the seat braces and align the ends of
the bench with the edge of the table top. Use a 1/8"
drill bit to avoid splitting. Attach the seat bench to
the braces using eight 2½" wood screws per bench
seat. Repeat for opposite seat bench. (See Figure 5)
CARE AND MAINTENANCE
1. Clean the table with a cleaner/brightener that
contains mildewcide.
2. Apply an outdoor wood sealer that contains water
repellent and an ultraviolet stabilizer.
NOTE: Allow table to dry outside for two weeks
prior to painting or staining.
Figure 2
Figure 3
Figure 4
Figure 5
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com