U-Line H-4405 User manual

PAGE 1 OF 2 1213 IH-4405
πH-4405
STEEL FRAME
PICNIC TABLE
1-800-295-5510
uline.com
TOOLS NEEDED
Power Drill
9/16"Phillips
Drill Bit Hammer
1/2"Phillips
Drill Bit
3/8"Phillips
Drill Bit
29" Support Brace x 2
26½" Center Brace
Board x 5 Leg Frame x 2
Nut x 3
Washer x 3 #14 Self-Tapping
Screw x 6
5/16"Bolt x 3
Brace Hardware
Socket Wrench
1/2" Socket
9/16" Socket
ASSEMBLY INSTRUCTIONS
PARTS
Nut x 20 Washer x 20 3/8"Bolt x 20
1. Stand up the leg frames and loosely attach one
boardin the center of the tabletop using the 3/8"
bolts, washers and nuts. (See Figure 1)
NOTE: The frame lips should face toward the
outside of the table.
Board
Frame Lip
Leg Frame Figure 1

PAGE 2 OF 2 1213 IH-4405
2. Attach the remaining two boards to form the table
top using the 3/8" bolts, washers and nuts.
(See Figure 2)
3. Turn the table upside down.
4. Attach the support braces to the leg frames using
the brace hardware: 5/16" bolts, washers and nuts.
(See FIgure 3)
NOTE: For a cleaner end look, insert the bolt
through the support brace first and attach
with the washer and nut. When the table is
upright the bolt head is exposed, not the
bolt end and nut.
5. Connect the support braces to the center brace.
(See Figure 4)
6. Attach the center brace to the table top using self-
tapping screws so the tabletop is level. (See Figure 5)
7. Turn the table right-side up.
8. Attach the remaining two boards for the seats using
the 3/8" bolts, washers and nuts. Tightly secure all
bolts. (See Figure 6)
ASSEMBLY INSTRUCTIONS CONTINUED
Support Braces
Center
Brace
Center
Brace
Figure 2 Figure 4
Figure 5
Figure 6
Support Brace
Leg Frame
Figure 3
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com