Uberhaus TP-091031504 User manual

1
72255004
ASSEMBLY INSTRUCTIONS
12' x 12' Sunshelter
ITEM# TP-091031504

2
Tools required: ladder, hammer screwdriver (not included)
A Center Connector 1
B Long Bar 4
B1 Bar 4
C Short Bar 4
D Corner Connector 4
E Arm Connector 4
F-1 Lintel 4
F-2 Lintel
4
G Post 4
Parts List
L Air Vent 1
M Canopy 1
N Screen 4
Parts List

3
STEP1:
1. Attach lintel (F-1) to lintel (F-2) then to arm connector (E) with bolt (J). Attach 4 lintel
assemblies as illustrated.
2. Attach lintel (F-1) to lintel (F-2) to post (G) with bolt (I), make them into a square.
3. Attach the corner connector (D) to lintel (F-1\F-2) with bolt (J).
I Bolt
1/4”-0.6” 16
J Bolt
1/4”-1.25” 24
Q Wrench 2
Hardware Used in Step 1
1. 2. 3.

4
4. Attach the long bar (B), short bar (C) to center connector (A), then install this
assembly at the top of the shelter.
5. Attach the long bar (B) to bar (B1), then attach the bar (B1) and corner connector (D) to
the assembled frame with bolt (J). Attach the short bar (C) to arm connector (E) with bolt
(J).
J Bolt
1/4”-1.25” 8
Hardware Used in Step 2
4.
5.

5
6. Cover the canopy (M) onto the top of the gazebo (Do not cover tightly), then cover the
air vent (L) onto the small top. Tie each corner of the canopy and cover the four corner
knots onto the end of the bar (B1), then tie each side in the missdle and cover the middle
knots onto the end of the short bar (C).
7. Attach the Base Plate (R) to Post (G) with bolt (I).
Secure the shelter to the ground by inserting each stake (H) into the hole of the post (G).
Hardware Used in Step 3
Hardware Used in Step 4
H Stake 8
I Bolt
1/4”-0.6” 4
R Base Plate 4

6
F-2
F-1
N:Netting P:Plastic Hanger
F-1
8．The screen (N) is hanged to the slip tube with plastic hangers (P).
Your sunshelter is now ready to be used.
MAINTENANCE:
1. This sun shelter is not a permanent structure and should be disassembled & stored away
after use.
2. Do not repack your sun shelter until it is completely dry.
3. This sun shelter must be assembled by two adults or more.
4. This sun shelter must not be left erect in high-wind conditions
Hardware Used in Step 5
P Plastic Hanger 40