URBAN OUTFITTERS MARIELLA 49189418 User manual

MARIELLA HEADBOARD SHELF
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 1 of 2
(A)
Screw JP
[#8 x 50mm] x4
(B)
Plastic Anchor
[ S6 ] x4
(1)
Shelf x1
URBAN OUTFITTERS
TOOLS REQUIRED BUT NOT INCUDED:
Phillips head screwdriver, Pencil, Level
Do not throw away packing materials and carton until after assembly.
Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place over heat or air
conditioning vents. Adjust levelers so that the furniture sits flat on uneven
floors.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
PARTS INCLUDED:
16-3/8”
64”
11-7/8

EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 2 of 2
STEP 1
A) Locate the desired position of the Shelf (1) on the wall and ensure the shelf is level. If attaching to drywall,
mark the location of the (x4) holes in the shelf on the wall and then remove the shelf.
B) Pre-drill holes for the Wall anchors (B) at the marked locations with a drill and then insert the anchors.
C) Place the Shelf (1) back over the wall anchors and insert the Screws (A). Tighten with a Phillips head
screw driver or a drill.
D) If drilling into a stud, Place the Shelf (1) on the wall and insert Screws (B) through the bracket into the
drywall. Tighten with a Phillips head screw driver or a drill.
MARIELLA HEADBOARD SHELF
Assembly Instructions
URBAN OUTFITTERS