URBAN OUTFITTERS MARGOT 80422900 User manual

Page 1 of 3
MARGOT FLOOR MIRROR
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.© 2017 UO, Inc.
All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized
reproduction, adaptation, distribution or other infringement will be prosecuted.
TOOLS REQUIRED BUT NOT INCUDED:
Screwdriver, Drill, Hammer, Level, Pencil
WARNINGS:
Do not throw away packing materials and carton until after assembly.
Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place overheat or air
conditioning vents. Adjust levelers so that the furniture sits flat on uneven
floors. Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
PARTS INCLUDED:
C) Screw
[D 0.35 / 0.19 x 2.32”] x4
or
[D 8.9/4.8 x 59 mm]
A) Mirror
[21.9 x 1.2 x 64”] x1
or
[55.5 x 3 x 162.5 cm]
D) Plastic Anchor
[D 0.35 ” x 1.4” Bolt] x 4
or
[D 9 x 36 mm]
B) French Cleat
[11.8 x 1.97 x 0.2”] x1
or
[30 x 5 x 0.5 cm]

Page 2 of 3
MARGO FLOOR MIRROR
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.© 2017 UO, Inc.
All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized
reproduction, adaptation, distribution or other infringement will be prosecuted.
STEP 2
Pre-drill holes for the plastic anchors (D) with a drill at the marked hole locations and use a hammer to tap them into
the wall. Align the Loose French Cleat (B) and insert screws (C). Tighten with a Phillips head screw driver.
STEP 1
Locate the desired position of the mirror (A) on your wall and mark the position lightly on the wall. Measure the
distance from the floor to the bottom of the French cleat attached to the back of the mirror and subtract 1cm
(~3/8") to determine the mounting height for the loose French cleat (B). Mark the mounting height on the wall
and align the holes on the loose French cleat (B) to the marked mounting height. Ensure the cleat is level and
mark the location of the holes in the loose French cleat (B) on the wall.

Page 3 of 3
MARGO FLOOR MIRROR
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.© 2017 UO, Inc.
All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized
reproduction, adaptation, distribution or other infringement will be prosecuted.
STEP 3
Hang the mirror (A) on the French cleat now attached to the wall to complete the installation.