URBAN OUTFITTERS Tabitha 65443186 User manual

TABITHA SH
ELF
Assembly
Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN
OUTFITTERS,
©
2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution
or
prosecuted.
Avoid direct exposure to sunlight. Do not place over
heat
Adjust levelers so that the furniture sits flat
on uneven floors.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden
area.
You may need to re-tighten all bolts after initial use.
TIP KIT
A
B
Nylon strip
Bracket
Quantity: 1pc
Quantity: 2pcs
ELF
Instructions
OUTFITTERS,
INC.
2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
or
other infringement will be
unt
heat
or Air conditioning vents.
on uneven floors.
area.
B
C D
Bracket
Screw
Quantity: 2pcs
M3 x 32mm
Quantity: 2pcs
Page 1 of 2
2
C D
Screw
M3 x 19mm
Quantity: 2pcs
TOOLS REQUIRED BUT NOT INCLUDED:
Phillips head screwdriver
Do not throw away packing materials and carton until after
assembly. Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:

TABITHA SH
ELF
Assembly
Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN
OUTFITTERS,
©
2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution
or
prosecuted.
STEP 1
Align the Anti Tip
Brackets (B) to the Top back of the Case.
Insert Screws (C) and tighten completely. Do not overtighten
STEP 2
Contact your local hardware store to purchase the correct anchors for your wall
Align the brackets to the wall and make sure they line up
Screw the brackets to the wall using the correct anchors.
Slide the case to the wall. Leaving a little bit of room between the case and the wall.
Feed the Nylon Strap through both brackets and pull tig
ELF
Instructions
OUTFITTERS,
INC.
2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
or
other infringement will be
Brackets (B) to the Top back of the Case.
Insert Screws (C) and tighten completely. Do not
over-tighten.
Contact your local hardware store to purchase the correct anchors for your wall
-type.
Align the brackets to the wall and make sure they line up
with the brackets on the back of the case from step 1.
Screw the brackets to the wall using the correct anchors.
Slide the case to the wall. Leaving a little bit of room between the case and the wall.
Feed the Nylon Strap through both brackets and pull tig
ht.
Page 2 of 2
2
with the brackets on the back of the case from step 1.