URBAN OUTFITTERS SANNA User manual

Assembly Instructions
Do not throw away packing materials and carton until after assembly.
Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place over heat or Air conditioning vents.
Adjust levelers so that the furniture sits flat on uneven floors.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 1 of 4
SANNA MEDIA CONSOLE
HARDWARE LIST
TOOLS REQUIRED BUT NOT INCLUDED:
Phillips Head Screw Driver
PARTS INCLUDED
(A) Door Pull
Quantity: 4pc
TIP KIT
(2) Bracket
Quantity: 4pcs (3) Nylon strip M4 x 20mm
Quantity: 2pcs
(4) Screw
M4 x 20mm
Quantity: 4pcs
(5) Screw
M4 x 35mm
Quantity: 4pcs
(6) Wall blug
4 x L40
Quantity: 4pcs
(1) Bolt
M4 x 25mm
Quantity: 4pcs

Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 2 of 4
STEP 1.
STEP 2.
Unscrew the Door Pulls (A).
Align the Door Pulls (A) as shown. Insert the Screws (1) from the back and tighten with
screwdriver. Adjust the levelers so the Media Console sits flat on the ground.
1 A
SANNA MEDIA CONSOLE

Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 3 of 4
STEP 3.
STEP 4.
Side view
2
43
6
5
2
2
Align the anti tip brackets (2) to the top back of the case.
Insert Screws (4) and tighten completely. Do not overtighten.
Contact your local hardware store to purchase the correct anchors for your wall-type.
Align the brackets to the wall and make sure they line up with the brackets on the back of the case from step 3.
Screw the brackets to the wall using the correct anchors.
Slide the case to the wall. Leaving a little bit of room between the case and the wall.
Feed the Nylon Strap through both brackets and pull tight.
2
4
3
SANNA MEDIA CONSOLE

Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 4 of 4
FINISH
SANNA MEDIA CONSOLE