URBAN OUTFITTERS ARIA User manual

ARIA HEADBOARD
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted.
Page 1 of 3
TOOLS REQUIRED BUT NOT INCLUDED:
Phillips head screwdriver
Level
Pencil
Straight edge
Do not throw away packing materials and carton until after
assembly. Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place overheat or air
conditioning vents. Adjust levelers so that the furniture sits flat on
uneven floors.
Blot spills do not rub, with a clean white cloth. Do not use harsh
chemicals.
Before cleaning any part test a small spot in a hidden area. You
may need to re-tighten all bolts after initial use.
PARTS INCLUDED
(C) Metal Anchor
[M15 x 28mm] x6
(D) Machine Screw
[M8 x 35mm] x6
A) Headboard
x1
B) Cleat
x2

EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 2 of 3
STEP 1
A) With help, determine the desired location of the headboard (A) (recommended min. height shown below).
Ensure headboard (A) is level and mark a line across the top, and down the sides with a pencil. Mark the center of the
headboard (A) with a pencil on the top line.
B) Locate the vertical position of the cleat (B) holes by measuring 390 mm or 15.35” straight down from the top line at its
center. Mark the position with a pencil.
C) Locate the horizontal position of the first cleat (B) holes by measuring 301 mm or 11.85” to the left and right of the
center. Ensure level and mark the location with a pencil.
D) Center the first holes of the cleat (B) on the marked locations of holes on the wall, ensure level, then mark the
locations of the additional two holes. Remove the cleat and screw the metal anchors (C) into wall at the marked
locations.
E) Attach cleats (B) by screwing machine screws (D) through the cleats into the metal anchors (C).
ARIA HEADBOARD
Assembly Instructions

EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 3 of 3
STEP 2
With help hang the Headboard (A) onto the French Cleat (B).
ARIA HEADBOARD
Assembly Instructions