urmet domus miro 1183 User manual

DS 1183-013 LBT 20108
Mod.
1183
CITOFONO VIVAVOCE 2VOICE
2VOICE HAND-FREE DOOR PHONE
INTERPHONE MAINS-LIBRES 2 VOICE
INTERFONO MANOS LIBRES 2VOICE
SPRECHANLAGE 2VOICE
Sch./Ref.1183/7

7
DS1183-013
ENGLISH
The door phone Ref. 1183/7 is designed for use in 2Voice system audio door phone and video door
phone installations.
DESCRIPTION OF COMPONENTS
1
6
10
11
9
8
12
7
2
3
4
5
13
14
SW1 SW2
1. Microphone
2. Button see button function table
3. Button see button function table
4. ButtontoconnecttoYokisdevices;contactsX1,GT:max50mA@12Vcc
5. ButtontoconnecttoYokisdevices;contactsY1,GT:max50mA@12Vcc
6. Multicolour indicator LED
7. Call and conversation speaker
8. Button used to activate/deactivate audio
9. Green LED under the button
10. Door opener button
11. Green LED under the button
12. Terminals for connecting to the system
13. Line termination jumper
ONOFF
14. Congurationdipswitch(SW1-SW2):
n.1ofSW1,denesthedoorphoneoperatingmode:OFF“HandsFree”(default)/ON“Pushto
talk”
n.2÷8ofSW1,denetheapartmentnumberinthecolumn;
n.1÷2ofSW2,denethestationnumberintheapartment.
SW1 SW2
Refer to the system booklet for how to set the dip switches.
= =
ON
ON
–
–
–

8DS1183-013
INSTALLATION
WITH FLUSH-MOUNTED CASING MOD. 503
Installush-mountingboxattheheightindicatedinthedrawingbelow.
Fixthebrackettothemountingbox.
Box Mod. 503
Metal bracket
1,55 m
n° 2 M3,5 x 19 mm
included
Connect.
Fixthevideodoorphonetothebracket.
1
2
WITH FLUSH-MOUNTED CASING Ø 60 MM
Installush-mountingboxattheheightindicated.
Removetheplasticbasefromthedoorphoneunitandxthebasetothewallasshowninthedrawinghere
below.
1,55 m
n° 1 2,9 x 13 mm
countersunk screw
Box Ø 60 mm
n° 1 screw and screw
anchor included
Connect.
Fixthedoorphonetoitsplasticbase.
1

9
DS1183-013
WALL SURFACE MOUNTING
Removetheplasticbasefromthedoorphoneunitandxthebasetothewallasshowninthedrawinghere
below (you may want to use the drilling template supplied at the end of this manual).
n° 2 screws and screw
anchors included
1,55 m
Connect.
Fixthedoorphonetoitsplasticbase.
1
TERMINAL PINS DESCRIPTION
GT Buttoncommonterminals and
Y1 Button
X1   Button
S-
}
Supplementary ringer
S+
]
CP Floorcall
]
LINE System bus connection

10 DS1183-013
BUTTON FUNCTIONS
State
Button
STAND-BY
WAITING
FOR PICk-UP
(RECEIVING
CALL)
DURING AUDIO OPERATION
STAND-BY
AND BUTTON
PRESSED
STATE OF
PROGRAMMING*
(ONLY WITH
DOOR PHONE IN
STAND-BY)
Open
pedestrian
door
Open
pedestrian
door Openpedestriandoor
Open
pedestrian
door
Connect / disconnect the
automatic door opening
system
--- Audio
activation
If pressed in the operating mode:
A)“HandsFree”endsthe
conversation;
B)in“Pushtotalk”:
if pressed a long time, it
enables the audio of the door
unit;
if short pressed it activates or
terminates the conversation.
—
—
---
Call volume adjustment
fordoorandoorlevel
calls (the possible volume
adjustments are, in this
order,HIGH,LOW,MUTE)
Special function
(default: 7)
Special
function
(default: 7) Special function (default: 7)
Programmable
intercom call
2 (Default: not
programmed)
Floorcallringtone
selection (5 different ring
tones)
Garage door
opener Garage door opener Garage door opener
Programmable
intercom call 1
(Default: call to
switchboard)
Door phone call ring tone
(5 different ring tones)
(*) To enter and exit programming state, hold button pressed for longer than 5 seconds. The yellow LED
will blink slowly to indicate that programming mode is selected. Programming mode will shut down in all
cases after the 10 minute timeout.
INDICATOR LEDS
6. Multicolour indicator LED
PRIORITY FUNCTIONS
1Fastashingred:mutedringtones
2 Green blinking: automatic door opener on
3 Red on steady: main calling station door open
4 Slowly blinking red: secondary calling station door open
5 Slowly blinking yellow: programming state on
To save the programming, remember to exit from the same by pressing the button for more
then 5 seconds; in any case, after 10 minutes the device exists the programming state and saves
the parameters changed. Refer to the system booklet for how to program intercom calls.
9. Green LED under the button
 Onsteady: callinprogress
 Onblinking: conversationongoing
11. Green LED under the button
 Onsteady: possibilityofadooropening
RESET
To restore default parameters of the device after entering programming mode, hold button pressed for
longer than 5 seconds, press the and buttons together for longer than 3 seconds. The system will
emit2longbeepstoconrmandexittheprogrammingstate.

11
DS1183-013
ACTIVATING AUDIO BY PRESSING THE (PUSH TO TALk MODE)
BUTTON
If the communication between the calling station and the door phone is disturbed, it is possible to activate
the two audio channels (inwards and outwards) individually.
After having received a call, short press to activate the audio from the door unit, then if the button is held
pressed down, the audio channel is activated externally and the user can speak to the caller. To listen, it is
necessary to press the button.
To end the conversation, shortly press button.
Connection of a E2BP module to the door phone for the centralisation of lights and rollers
SD541-4002
MVR500ER
OFNLBP
Roller
MVR500ER
OFNLBP
ANTENNA
GT
X1
Y1
R1 R1
R1
R1
R1 R1
Roller
After suitably programming the Yokis devices, it will be possible:
to activate the centralised closing of the rollers with a button (for example: );
a second button (for example: ) will activate the turning off of the lights.
For more information on YOKIS products, please visit www.yokis.com
–
–

DS 1183-013 LBT 20108
Area tecnica
servizio clienti +39 011.23.39.810
http://www.urmet.com
e-mail:[email protected]
ProdottoinTUNISIAsuspecicaUrmet
ManufacturedinTUNISIAtoUrmetspecication
URMETS.p.A.
10154TORINO(ITALY)
VIABOLOGNA188/C
Telef.  +39011.24.00.000(RIC.AUT.)
Fax  +39011.24.00.300-323
UP
83,5 mm
Zona passaggio cavi
Cable routing area
Zone passage câbles
Zona de paso de cables
Kabelführungsbereich
DIMA DI FORATURA
DRILLING TEMPLATE
GABARIT DE PERÇAGE
PLANTILLA DE PERFORACIÓN
BOHRSCHABLONE