urmet domus 1158/46 Operating instructions

Sch. 1158/46
Keypad programming guide
Note there are NO DEFAULT CODES in the 115
8
/
46
keypad and
Urmet do not have any record of the Engineer’s Password.
If you do not know the Engineer’s Password then it will be
necessary to gain access to the rear of the keypad

There are two possibilities when programming the 1158/46 keypad;
1. You know the Engineer’s Password (3 to 8digits).
In this case the keypad can be programmed without being removed from its housing.
See Page 2
2. You do not know the Engineer’s Password.
Continue on this page.
Before starting, choose an Engineer’s Password with 3 to 8 digits (This can be used later to
change the Door Open Code). And choose a Door Open Code.
Remove the keypad from the housing.
With reference to the following diagram, press the Programming switch three times in quick
succession –
You will hear BEEP BEEP BEEP and the Red LED will come on.
Enter your chosen Engineer’s Password and press (BEEP BEEP BEEP and Red LED goes off).
The keypad is now in the normal operating mode and an Engineer’s Password has been stored.
Press then enter your chosen Engineer’s Password then press (BEEP BEEP
BEEP). If you hear one long BEEP instead of three short beeps you must repeat the above until you
do hear three BEEPS.
Enter 31 11 XX where XX is the relay time in seconds e.g. for 5 seconds enter 31 11 05, for 10
seconds enter 31 11 10, then press (BEEP BEEP BEEP).
Enter 01 DOOR OPEN CODE then 1(BEEP BEEP BEEP). The DOOR OPEN CODE can be
from 3 to 8 digits.
Press and hold until you hear a long BEEP to exit programming.
Page 1

To change the Door Open Code
Press then enter the Engineer’s Password and press (BEEP BEEP BEEP).
Press 90 OLD DOOR OPEN CODE then press .
Enter the new Door Open Code and press .
Press and hold until you hear a long BEEP to exit programming.
To change the Door Open Time
Press then enter the Engineer’s Password and press (BEEP BEEP BEEP).
Enter 31 11 XX where XX is the relay time in seconds e.g. for 5 seconds enter 31 11 05, for 10
seconds enter 31 11 10, then press (BEEP BEEP BEEP).
Press and hold until you hear a long BEEP to exit programming.
Tel [phone]
www.urmet.co.uk
[email protected]
Page
2