urmet domus FD-060-001 User manual

KEYPAD-OEM (FD-060-001)
(OEM keypad used in Urmet stainless steel intercom panels)
Quick start guide
Note there are NO DEFAULT CODES in the KEYPAD-OEM (FD-060-001)
keypad and Urmet do not have any record of the Engineer’s Password.
If you do not know the Engineer’s Password then it will be necessary to gain
access to the rear of the keypad.

Step 1 –Program an Engineer’s Password
Move the EXPL/PROG jumper to the PROG position –
In the following example a 6-digit Engineer’s Password of 123456 will be programmed –
In summary move the EXPL/PROG jumper to the PROG position, press 00 0 6 123456 # then move the
EXPL/PROG jumper to the EXPL position.
Step 2 –Program a Door Open Code
In the following example a code of 2580 will be programmed in to memory position 1 –
Wait 30 seconds for the keypad to exit from the programming mode.
00 0 6 123456 #
Engineer’s Password
is stored in memory
position 1
Group
Number of digits in
the Engineer’s
Password (3 to 8).
Engineer’s
Password
Confirm
123456 01 042580 #
Engineer’s
Password
Memory
position
Group
Digits in the
door open code
(3 to 8).
Door Open
Code
Confirm
In summary press 123456 01 0 4 2580 # then wait 30 seconds

Step 3 –Program the Relay Time
In the following example Relay 1 time will be programmed to 5 seconds –
Wait 30 seconds for the keypad to exit from the programming mode.
123456 31 05 #
Engineer’s
Password
Relay 1
Relay
time
Confirm
In summary press 123456 31 04 # then wait 30 seconds
Tel [phone]
www.urmet.co.uk
[e-mail]