1. INTRODUCTION
The ADW-E series is designed and programmed according to the OIML R-76
Class III requirements.
This scale is sealed to prevent unauthorized access to internal parts.
Ender users should be advised not to undertake any trouble shooting
except those listed on the operation manual.
This maintenance manual containsof certain information that may result
in fraudulent use. Do not release any part of this manual to any end
users or un-authorized persons.
The internal mini jumper should be so set to prevent un-authorized
settings or alternations.
Should a load cell has been replaced, make sure that the protection
devices are properly set.
After servicing, it is necessary to go through all tests and procedures
to ensure the scale meets all the meteorological and approval
requirements.
Here are some features of the ADW-E series
1. Designed to meet OIML-R76 class III requirements.
2. Zero Indicator.
3. Net Indicator.
4. Negative Value Indicator.
5. Auto Tare Function.
6. Power on Zero Function.
7. Manual Zero Function.
8. Extended Display Function.
9. Auto Power Saving Function.
10. Metric/Avoirdupois Conversion Function.
11. Low battery warning signal.
12. Single points Calibration.
13. Mini jumper to prevent end-user calibration.
14. Optional EL backlights.
15. Optional RS232C interface.
16. Optional Rear Display
17. Built-in rechargeable battery operated.
18. Battery operating time: 200 hours plus after charged.
